Sony MEX-GS600BT operating instructions ZAPPIN*4, PARENTAL*5, Sound, Position, Balance, Fader

AUX-A*1*2(AUX Audio)

Activates the AUX source display: “ON,” “OFF” (page 38).

CT (Clock Time)

Activates the CT function: “ON,” “OFF” (page 12).

BTM*3 (page 11)

ZAPPIN*4

ZAP TIME (Zappin Time)

Selects the playback time for the

ZAPPIN function.

–“Z.TIME-1 (about 6 seconds),” “Z.TIME-2 (about 15 seconds),” “Z.TIME-3 (about 30 seconds).”

ZAP BEEP (Zappin Beep)

Applies a beep sound between track passages: “ON,” “OFF.”

PARENTAL*5

Sets the parental lock to “ON” or “OFF,” and edits the passcode (page 39).

*1 When the unit is turned off.

*2 Does not appear in App Remote.

*3 When the tuner is selected.

*4 When the CD or USB is selected.

*5 When the SiriusXM Vehicle Tuner is connected.

SOUND:

EQ7 PRESET (page 33)

EQ7 SETTING (page 33)

POSITION

SET F/R POS (Set Front/Rear Position) (page 34)

ADJ POSITION*1 (Adjust Position) (page 34)

SET SW POS*1 (Set Subwoofer Position) (page 34)

BALANCE

Adjusts the sound balance: “RIGHT-15”

– “CENTER” – “LEFT-15.”

FADER

Adjusts the relative level: “FRONT-15” – “CENTER” – “REAR-15.”

DM+*2 (page 34)

LOUDNESS (Dynamic Loudness) Reinforces bass and treble for clear sound at low volume levels: “ON,” “OFF.”

ALO (Automatic Level Optimizer) Adjust the playback volume level of all playback sources to the optimum level: “ON,” “OFF.”

RB ENH*3 (Rear Bass Enhancer) RBE MODE (Rear Bass Enhancer Mode)

Selects the rear bass enhancer mode: “1,” “2,” “3,” “OFF.”

LPF FREQ (Low Pass Filter Frequency) Selects the subwoofer cut-off frequency: “50Hz,” “60Hz,” “80Hz,” “100Hz,” “120Hz.”

LPF SLOP (Low Pass Filter Slope) Selects the LPF slope: “1,” “2,” “3.”

SW DIREC*4 (Subwoofer Direct Connection)

SW MODE (Subwoofer Mode)

Selects the subwoofer mode: “1,” “2,” “3,” “OFF.”

SW PHASE (Subwoofer Phase) Selects the subwoofer phase: “NORM,” “REV.”

SW POS*1 (Subwoofer Position) (page 34)

Selects the subwoofer position: “NEAR,” “NORMAL,” “FAR.”

LPF FREQ (Low Pass Filter Frequency) Selects the subwoofer cut-off frequency: “50Hz,” “60Hz,” “80Hz,” “100Hz,” “120Hz.”

LPF SLOP (Low Pass Filter Slope) Selects the LPF slope: “1,” “2,” “3.”

36