Canceling the DEMO mode
You can cancel the demonstration display which appears while this unit is turned off.
1Press , rotate the control dial until “DISPLAY” appears, then press it.
2Rotate the control dial until “DEMO” appears, then press it.
3Rotate the control dial to select
The setting is complete.
4Press (BACK) to return to the previous display.
The display returns to normal reception/ play mode.
Setting the clock
The clock uses a
1Press , rotate the control dial until “GENERAL” appears, then press it.
2Rotate the control dial until “CLOCK- ADJ” appears, then press it.
The hour indication flashes.
3Rotate the control dial to set the hour and minute.
To move the digital indication, press
4After setting the minute, press
.
The setup is complete and the clock starts.
To display the clock, press .
Detaching the front panel
You can detach the front panel of this unit to prevent theft.
1Press and hold .
The unit is turned off.
2Press the front panel release button , then remove the panel by pulling it towards you.
Caution alarm
If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the
Note
Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.
Attaching the front panel
Engage part of the front panel with part
of the unit, as illustrated, and push the left side into position until it clicks.
7