Sony CDX-MP70 Storing station names, Operating with the card remote commander, Station Memo

Storing only desired stations

You can manually preset desired stations.

./> control dial

1 Press (SOURCE) repeatedly to select the radio.

2 Press (MODE) repeatedly to select the band.

3 Press the –mor M+ button to tune in the station that you want to store.

4 Press (MENU), then rotate the

./> control dial until “Preset

Edit” appears.

5 Press the ./> control dial.

6 Rotate the ./> control dial to select the number that you want to store.

7 Press the ./> control dial.

The stored station indication appears in the display.

8 Press (MENU) twice.

Note

If you try to store another station on the same stored number, the previously stored station will be erased.

Operating with the card remote commander

1 Press (SOURCE) repeatedly to select the radio.

2 Press (MODE) repeatedly to select the band.

3 Press (SEEK -)or (SEEK +) to tune in the station that you want to store.

4 Press the desired number button ((1) to (6)) until “MEM” appears.

Storing station names

— Station Memo

You can assign a name to each radio station and store it in memory. The name of the station currently tuned in appears in the display. You can assign a name using up to 8 characters for a station.

Storing the station names

1 Tune in a station whose name you want to store.

2 Press (MENU), then rotate the

./> control dial until “Name Edit” appears.

3 Press the ./> control dial.

4 Enter the characters.

1Rotate the ./> control dial to select the desired character.

A y B y C ... y 0 y 1 y 2 ... y

+y – y * ... y * y A

*(blank space)

2Press the M+ button after locating the desired character.

If you press the –mbutton, you can move back to the left.

3Repeat steps 1 and 2 to enter the entire name.

5 Press the ./> control dial.

Tips

•Simply overwrite or enter “ ” to correct or erase a name.

•There is another way to start storing station names: Press (LIST) for 2 seconds instead of performing steps 2 and 3. You can also complete the operation by pressing (LIST) for 2 seconds instead of step 5.

•If no memory is remaining, “Mem Full” appears in the display, and you cannot assign a station name.

continue to next page t 17