Sony MZ-R37 Section Electrical Adjustments, Precautions for Adjustment, Laser Power Check, TDYS-1

Ver 1.4 2001. 01

SECTION 5

ELECTRICAL ADJUSTMENTS

PRECAUTIONS FOR ADJUSTMENT

1)Perform all adjustments in the order given in the test mode. After adjusting, exit the test mode.

2)Use the following tools and measuring instruments.

• Test CD	TDYS-1
	(Part No. : 4-963-646-01)

•SONY MO disc available on the market

•Laser power meter LPM-8001

(Part No. : J-2501-046-A)

•Oscilloscope (Frequency band above 40 MHz. Perform the calibration of probe first before measuring.)

•Digital voltmeter

3)Unless specified othewise, supply DC 4.5V from the DC IN 4.5V jack.

4)Swtich, knob positions HOLD switch .............. OFF AVLS switch ................ NORM

LASER POWER CHECK

Connection :

laser

power meter

Optical pick-up objective lens

digital voltmeter

MAIN board

AP5117 (VCC)

AP574 (LDI0)

Adjustment Method :

1.Set the servo mode of the test mode (Mode : 000).

2.Press the ( key, and set the laser power adjustment mode (Mode : 020) using the VOLUME + or – key.

3.Press the =key and move the optical pick-up to the inner most circumference.

4.Open the cover and set the laser power meter on the objective lens of the optical pick-up.

5.Press the ( key, and set the laser CD/MO read adjustment mode (Mode : 021).

6.Check that the laser power meter reading is 0.85 ± 0.085 mW.

7.Check that the voltage between AP5117 (VCC) and AP574 (LDI0) at this time is below 40 mV.

8.Press the ( key, and set the laser MO write adjustment mode (Mode : 022).

9.Check that the laser power meter reading is 6.8 ± 0.68 mW.

10.Press the Pkey to finalize the adjustment data.

11.Check that the voltage between AP5117 (VCC) and AP574 (LDI0) at this time is below 80 mV.

12.Press the pkey.

13.Exit the test mode.

MO TRAVERSE ADJUSTMENT

Connection :

oscilloscope

MAIN board

SP526 (TE)

AP503 (VC)

Adjustment Method :

1.Set the servo mode of the test mode (Mode : 000).

2.Press the ( key, and set the MO test adjustment mode (Mode

: 030) using the VOLUME + or – key.

3.Press the =or + key and move the optical pick-up to the center circumference.

4.Insert any MO disk available on the market.

5.When the ( key is pressed, the MO read EF balance adjust- ment mode (Mode : 032) will be set after MO focus search adjustment mode (Mode : 031).

6.Press the Pkey to perform automatic adjustment, and check that the traverse waveform is symmetrical at the top and bottom.

7.Slide the REC key and set the MO write EF balance adjust ment mode (Mode : 034).

8.Press the Pkey to perform automatic adjustment, and check that the traverse waveform is symmetrical at the top and bottom.

(Traverse waveform)

A

0 V C

B

Specification : A = B, C >= 1.0 Vp-p

9.Check that the traverse level at this time is above 1.0 Vp-p.

10.Press the pkey.

11.Exit the test mode.

Note) Using a recorded disk in this adjustment will erase the data.

Adjustment Location : See page 19.

Adjustment Location : See page 19.

– 17 –