Storing telephone numbers
When the desired telephone number is displayed, press the | MENUOK | button. Select SAVE |
TO PB if necessary and press the MENUOK button. Enter the name and press the MENUOK | ||
button. Edit the telephone number if necessary. Press the | MUTE | button for deleting the |
last character or press and HOLD for deleting the whole number. You can enter a dialing pause (approximately 3 seconds) by pressing the PAUSE button.
Press the MENUOK | button again to select a melody for the entry. |
Press the MENUOK | button to store the entry. |
Base layout
1
2
3
Deleting telephone numbers
When the desired telephone number is displayed, press the Select DELETE or DELETE ALL if necessary and press the entries will be deleted.
MENU
OK
MENU
OK
button.
button. The entry or all
4
Troubleshooting
Telephone
No dial tone
●Check or repeat installation steps:
-Make sure the base power is connected to a working electrical outlet.
-Make sure the telephone line cord is connected to the base and the wall jack.
●Connect another phone to the same jack. If it doesn’t work, the problem might be your wiring or local service.
●The handset may be out of range of the base. Move closer to the base.
●Make sure the battery is properly charged (for 16 hours).
●Make sure the battery in the handset is properly installed.
●The handset should beep when you press the TALK button, and the charge indicator on the base should lit when the handset rests in the cradle, If not, the battery may need to be charged.
●Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
●Make sure the ringer switch is set to the ON position.
●The handset may be out of range of the base. Move closer to the base.
●Check for a dial tone.
You experience static, noise, or fading in and out
● The handset may be out of range of the base. Move closer to the base. ● Make sure the base is not plugged into an electrical outlet with another
household appliance. If necessary, relocate the base. ● Charge the battery for 16 hours.
17
1.Charging / in use (flashing)
2.Display for answering machine
3.Power
4.Key for answering machine:
Key |
|
|
|
| In idle mode | During playback | |||
|
|
|
|
|
|
|
| briefly: check number of rings | decrease speaker volume |
|
|
|
|
|
|
|
| press and hold: set number of rings |
|
|
|
|
|
|
|
|
| briefly: turn answering machine on/of | stop playback |
|
|
|
|
|
|
|
| press and hold: select OGM |
|
|
|
|
|
|
|
|
| briefly: play OGM | back to previous message |
|
|
|
|
|
|
|
| press and hold: record OGM | (during settings: decrease value) |
|
|
|
|
|
|
|
| briefly: check remote PIN | increase speaker volume |
|
|
|
|
|
|
|
| press and hold: set remote PIN |
|
|
|
|
|
|
|
|
| briefly: confirmation “Delete all“ | Delete current message |
|
|
|
|
|
|
|
| press and hold: delete all messages |
|
|
|
|
|
|
|
|
| briefly: (no function) | skip to next message |
|
|
|
|
|
|
|
| press and hold: record memo | (during settings: increase value) |
|
|
|
|
|
|
|
| briefly: playback messages | Pause |
|
|
|
|
|
|
|
|
|
|
5.Paging key
6.Microphone
7.Charging contacts for handset
6
5
6
7