Installing the phone
Installing the Handset Battery
Inserting the batteries
Open the battery compartment cover, install the battery and replace the battery cover.
Attention: : Use only power adaptors and batteries supplied with this product. To order a replacement please call customer support :
Charging the batteries
Before the handset is used for the first time, insert it in the base station / charging station for at least 16 hours.
The handset warms up during the charging process. This is normal and
does not represent a risk. The battery status is shown on the display. When the battery capacity is nearly exhausted, the battery symbol will flash in the display. End your call and place the handset into the base or charging station for charging.
After a short time, the battery symbol will appear to be fully charged but this is actually not the case. The battery capacity will decrease rapidly. We advise you to put the handset on the base unit for 12 hours so that it can be recharged completely.
Install the
battery pack
Basic operation
Answering a call
Press the TALK button, to answer a call.
Making a call
Enter the phone number, using telephone key pad. Delete wrong characters by pressing the MUTE button. Press and HOLD the MUTE button to delete entire entry.
Press the TALK button , and the phone number is being dialed.
You can also press the TALK button, and you will hear the dialing tone. The entered number will be dialed immediately. It is not possible to correct wrong digits individually using this dialing procedure.
Ending a call
Press the TALK button or replace the handset in the base station.
Call timer
Your handset automatically times the duration of every call.
Activating handsfree
During a call operation you can switch On/Off the speaker.
Press the CID
button. The 
appears in the display when the speaker is ON.
| Replace the |
Base station | cover |
1.Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place your cordless telephone on a level surface, such as a desktop or tabletop, or you may mount it on the wall.
Main power outlet 
Modular phone wall jack
2.Plug one end of the telephone line cord into the TEL LINE jack on the back of the base and the other end into a modular jack.
3.Plug the AC power converter into the electrical outlet and the DC connector into the jack on the back of the base.
4.Place the handset in the base cradle. The charge/in use voice mail indicator turns on, verifying the battery is charging.
Setting the speaker volume
Press the VOLUME button.
During a call you can adjust the volume from 1 to 5.
Muting the microphone
Press the MUTE button.
During a call you can switch your handset’s microphone off. The display shows 
. To unmute press the MUTE again.
Redial
Your handset saves the last 3 dialed telephone numbers
Viewing/dialing telephone numbers
The handset is in idle state
Press the REDIAL button repeatedly (if necessary) until the desired telephone number is displayed.
Press the TALK button. The phone number is being dialed.
When you press the TALK button and hear the dialing tone, the very last dialed telephone number is dialed by pressing theREDIAL button.
7 | 16 |