Emerson MP2-115HW user manual Wiring Instructions

Wiring Instructions

1.Remove the wiring access doors by removing the two Phillips head screws that secure them.

2.Determine which of the two available conduit entry points are to be used. Knock out the conduit entry hole for the location and size of conduit to be used.

3.Connect conduit bushing and conduit and run utility load wiring. Inspect wiring to ensure it is not pinched. Make connections to the terminal blocks as labeled. The wiring terminals are labeled.

4.Close the wiring access doors and install the retaining screws.

CAUTION - RISK OF ELECTRIC SHOCK, SO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION - RISK OF ELECTRIC SHOCK, THIS UPS RECEIVES POWER FROM MORE THAN ONE SOURCE-DISCONNECTION OF THE AC SOURCES IS REQUIRED TO DE-ENERGIZE THIS UNIT BEFORE SERVICING.

CAUTION - FOR USE IN A CONTROLLED ENVIRONMENT. REFER TO MANUAL FOR ENVIRONMENTAL CONDITION.

Model No. : MP2-115HW
Desc.	: Micro Pod	C UL US
Input	: 120VAC 12A
	50/60Hz, 10	LISTED
Ouptut	: 120VAC 12A	91N6
	50/60Hz, 10	U.P.S. Accessory
MADE IN TAIWAN		612-XXXXX-00

Extract screws to remove

wiring access doors

Left Side of POD Right Side of POD

	wcircuit	CAUTION:
A		To
NSI/N	branchcircuitreduce
FPAaccordance		the
70. ith providedwrisk
	overcurrent am
	the	ith of
	Nationa	15fire,
		pe
	lprote resconnect
	Electricction		nly
			m o
		inaxim toa
	Code		um

Knockouts for Conduit

14		L
-
12AWG		NInput
8Kgf
	-
	cm

Input Terminal Block Connections

	L		m
			-c
			gf
Output	N		8K
		G
		AW
		-12
		14

Knockouts

Output Terminal for Conduit Block Connections

9