Emerson MP2-115HW user manual Apply Feed Power, Attaching POD to securing brackets

Page 14

APPLY FEED POWER

1.Next attach the POD to the securing brackets (see Figure 7). The POD can be installed to face one of three different directions utiliz- ing the same mounting procedures. Select the direction of mount- ing to accommodate the conduit entry connections.

Figure 7 Attaching POD to securing brackets

2.Make sure the 2U POD rotary switch is in the UTILITY position. Close the branch circuit breaker providing UTILITY input power.

! WARNING

The 2U POD is now electrically live. The UTILITY lamp (amber) should now be illuminated.

3.Plug the UPS input cord into the receptacle on the front of the 2U POD labeled “CONNECT UPS LINE CORD HERE.”

! WARNING

The UPS system is now electrically live.

4.Connect the 2U POD UPS output cord (labeled “CONNECT TO UPS OUTPUT RECEPTACLE”) to the output of the UPS system.

10

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Power Output Distribution Volt Page Table of Contents Figures Important Safety Instructions Page Glossary of Symbols System Description Introduction and System DescriptionRack Mount Installation LoadInstallation on GXT 2U UPS Attaching POD securing brackets to rear of UPSElectrical Installation Considerations Hardwire ConnectionsElectrical Connections Rear ViewWiring Instructions Apply Feed Power Attaching POD to securing bracketsStart Equipment UPS Available Indicator LampsUtility Operation Transfer to Maintenance BypassTransfer to UPS Troubleshooting Problem Cause SolutionProduct Warranty Registration SpecificationsPage Page 2U Hardwire POD
Top Page Image Contents