Panasonic SL-DZ1200 manual Inserting-removing a disc or SD Memory Card

Page 10

Inserting-removing a disc or SD Memory Card

Basic operations

Rear panel

Front panel

Power lamp

With the label face up

Inserting a disc

1.Press [POWER OFF ON] on the rear of unit

The unit power is on. The display comes on and the power lamp lights.

2.Insert a disc

Insert the disc flat and parallel into the CD slot, with the label up. The unit will automatically load the disc.

You cannot use an 8 cm disc.

Note

Do not insert a disc when the power is off.

Do not insert 2 or more discs.

Do not try to insert the disc using unnecessary force that may bend the disc. When the unit is loading or ejecting a disc, do not apply opposing force to the disc. Not following the above steps may re- sult in damage to the disc or unit.

Removing a disc

While stopped or while paused

Front panel

SD ACCESS

indicator

With the label face up

SD Memory Card

Inserting a SD Memory Card

1.Open the SD Memory Card slot lid

2.With the label on the card facing up and the notched edge facing the unit, insert the card

3.Insert until the card locks into place

4.Close the lid

Removing a SD Memory Card

After confirming the SD ACCESS indicator is not flash- ing, open the lid and press on the center of the SD Memory Card to release the lock and pull the ejected card out carefully, then close the lid.

The SD ACCESS indicator flashes when the SD Memory Card is being accessed. Do not turn off the power or try to open the lid and remove the card while the indicator is flashing. (Doing so may result in a loss of saved data.)

Note

Make sure to always close the SD card slot lid.

If you try using when the lid is open, “NO SD CARD” or “SD LID OPEN” will appear in the display and operation will not be pos- sible.

1. Press [ CD EJECT]

Press the button and the disc will come out.

If you press while playing in TURNTABLE mode, a message ap- pears in the display and play continues. Make sure to press af- ter pausing play.

If you do not remove the disc within approximately 10 seconds the unit will automatically re-load the disc.

To remove

2. Press again

Remove as indicated in the illustration without touching the playing surface.

Forced disc eject

You can forcefully eject a disc when the disc does not eject even after pressing [ CD EJECT].

 

Playable media

Reference

 

Page

 

 

 

 

 

 

 

25

 

 

 

CD

CD-DA audio that is finalized on a

 

CD-R or CD-RW

 

 

12, 22

 

 

 

MP3 files

 

 

 

(WMA is not supported)

 

 

 

 

SD Memory Card

Secure AAC

 

Secure MP3

22

(SD audio)

(WMA is not supported)

 

 

 

 

 

 

1. Press [POWER

OFF

ON] to turn the power off

2. Press [POWER

OFF

ON] again holding down

[

 

 

CD EJECT] to turn the power on, and then release

[

 

 

CD EJECT] after “DZ1200” appears in the display

10

RQT7114

Image 10
Contents Direct Drive Digital Turntable Table of contents Product serviceListening caution UseImportant Safety Instructions Before useFront panel Main featuresControl panel Rear panelFront panel Component part namesControl panel Rear panelPlatter setup SetupListening with the headphones Connecting with the DJ mixerConnecting with other mixers ConnectionsConnecting with the stereo amplifier Not using the DJ mixer Connecting the control terminals for relay playConnecting to equipment with digital input terminals Inserting-removing a disc or SD Memory Card Displaying the remaining time Display indicatorAdjusting the display contrast Changing the display anglePlaying a CD or SD Memory Card basic play Auto Cue function Turntable mode onlyTurn Volume Playing CD-R and CD-RW discsSwitch Play Select to select the me- dia to be used Press Power OFF onSwitch Mode to Turntable Insert a disc or SD Memory CardAdjusting the platter brake Basic function settingsUsing the Free Wheel mode Adjusting the auto cue levelBasic play for DJs Platter operationsChanging play with your hand AdvancedLocking the pitch Changing tempo and direction of playChanging tempo Reverse play Reversing the platterPlaying from memory Setting the cue point at any pointSetting the auto cue point Play from the stored pointStoring to the CUE Pads and playing Playing from memoryStore desired points to memory and play loop play Erasing cue pad, sample pad, loop play data Select play mode and playRecording to the Sample Pads and playing Recording to the Sample Pads in real-timeChange sound with combined per Changing the soundChanging sound to simulate analog FormanceInsert a SD Memory Card Saving to a SD Memory Card, RecallingSaving to a SD Memory Card Save the dataRecalling loading data saved on a Formatting the SD Memory CardRegarding MP3 albums and SD audio SD Memory CardUsing two units for relay play Using with other equipmentStart play using the mixer’s fader Using the amplifier and other equipmentLinking different tracks Unit’s initialize memory functionGlossary Initializing this unit’s memoryConcerning CDs Handling SD Memory CardsReference Problem Cause Solution Frequently asked questionsTroubleshooting guide Question AnswerSpecifications Error messagesMaintenance To clean this unit, wipe with a soft, dry clothLimited warranty only for U.S.A Panasonic/Technics DJ Products Limited WarrantyElectric Corporation of America Puerto Rico, Inc. PSC