Panasonic SL-DZ1200 manual Handling SD Memory Cards, Concerning CDs, Reference

Page 25
Rear side
Write Protect Switch

AAC

A compression standard that makes recording and play of high qual- ity audio possible including MPEG2 (an international standard). Used in SD Audio and broadcast satellite digital signals.

MP3

MP3 is the abbreviated form of the international standard MPEG1/ Audio Layer3. MP3 allows you to achieve approximately ten to one compression rates with bit rates of 128 kbps. MP3 is used widely with SD Audio, CDs, and computers.

Sampling frequency

The number of samples taken approximately each second when an audio signal is digitally converted and stored in memory. The higher the value the wider the frequency range can be used for digital con- version thus providing near original audio quality reproduction, how- ever the resulting size of the audio data does become quite large.

Bit rate

A value that indicates the audio signal compression rate. Indicates the number of bits sampled approximately each second, the larger the bit value the more information is contained resulting in better au- dio quality, however the size of the audio data does become quite large.

Handling SD Memory Cards

When handling SD Memory Cards

Avoid the following:

Altering or disassembling the SD Memory Card

Striking, bending, dropping, or getting water on the SD Memory Card

Touching the metal connectors with your fingers or with metal objects

Peeling off attached labels

Attaching new labels or stickers

Storage

Always put the SD Memory Card back in its case.

Do not store in potentially high temperature locations such as within cars, or in areas open to direct sunlight.

Do not place in locations subject to high humidity or dust.

Do not place in areas subject to caustic gases.

Protecting important data

Set the write protect switch to the

LOCK position. Release the lock when storing new data.

If there is a space for writing a note on the SD Memory Card, use a felt pen

(oil based) for writing. Do not use a pencil or ball point pen. Loss of data may result if the SD Memory Card is damaged.

Do not remove the AC power supply cord while the unit power is on (When the units display is on) or loss of data may result.

Do not remove the SD Memory Card from the unit during play. Loss of data may result.

Concerning CDs

With this system, you can only play CDs having this mark.

Do not use irregularly shaped CDs. (May result in damage to your equipment.)

Use discs that display the logo mark indi- cated above, or conform to the Compact

disc digital audio standard. The disc may not play properly if you are using a non- standard conforming disc.

For CDs with greater than 80 minutes total play time, the portion beyond 80 minutes cannot be played on this unit.

Depending on the CD, there may be apparent noise or the total number of tracks may not be read properly. In either case, try re- inserting the CD.

Recorded music CDs that are partially or fully translucent may not be usable with this unit.

Do not use CDs that are dirty.

Handling precautions

If you are taking the CD from a cold to a warm environment, mois- ture may form on the CD. Wipe this off with a soft, dry, lint-free cloth before using the CD.

Do not write on the label side with a ball-point pen or other writing instrument.

Do not use record cleaning sprays, benzine, thinner, static elec- tricity prevention liquids or any other solvent.

Do not attach labels or stickers to CDs. (Do not use CDs with ex- posed adhesive from tape or left over peeled off stickers.)

Do not use scratch-proof protectors etc.

Do not use CDs printed with label printers available on the market.

How to hold CDs

Do not touch the

recorded surface.

How to clean CDs

The recorded surface

Wipe from inside outward.

Reference

 

Storage precautions

Be sure to store CDs in their cases to protect them from dust, scratches, and warping.

Do not place or store CDs in the following places

Locations exposed to direct sunlight

Humid or dusty locations

Locations directly exposed to a heat vent or heating appliance

In the glove compartment or on the rear deck of an automobile

SD logo is a trademark.

 

 

 

MPEG Layer-3 audio decoding technology licensed from

25

Fraunhofer IIS and Thomson multimedia.

 

RQT7114

 

Image 25
Contents Direct Drive Digital Turntable Product service Table of contentsUse Listening cautionBefore use Important Safety InstructionsControl panel Main featuresFront panel Rear panelControl panel Component part namesFront panel Rear panelSetup Platter setupConnecting with other mixers Connecting with the DJ mixerListening with the headphones ConnectionsConnecting with the stereo amplifier Not using the DJ mixer Connecting the control terminals for relay playConnecting to equipment with digital input terminals Inserting-removing a disc or SD Memory Card Adjusting the display contrast Display indicatorDisplaying the remaining time Changing the display angleTurn Volume Auto Cue function Turntable mode onlyPlaying a CD or SD Memory Card basic play Playing CD-R and CD-RW discsSwitch Mode to Turntable Press Power OFF onSwitch Play Select to select the me- dia to be used Insert a disc or SD Memory CardUsing the Free Wheel mode Basic function settingsAdjusting the platter brake Adjusting the auto cue levelChanging play with your hand Platter operationsBasic play for DJs AdvancedChanging tempo Changing tempo and direction of playLocking the pitch Reverse play Reversing the platterSetting the auto cue point Setting the cue point at any pointPlaying from memory Play from the stored pointStoring to the CUE Pads and playing Playing from memoryStore desired points to memory and play loop play Recording to the Sample Pads and playing Select play mode and playErasing cue pad, sample pad, loop play data Recording to the Sample Pads in real-timeChanging sound to simulate analog Changing the soundChange sound with combined per FormanceSaving to a SD Memory Card Saving to a SD Memory Card, RecallingInsert a SD Memory Card Save the dataRegarding MP3 albums and SD audio Formatting the SD Memory CardRecalling loading data saved on a SD Memory CardStart play using the mixer’s fader Using with other equipmentUsing two units for relay play Using the amplifier and other equipmentGlossary Unit’s initialize memory functionLinking different tracks Initializing this unit’s memoryConcerning CDs Handling SD Memory CardsReference Troubleshooting guide Frequently asked questionsProblem Cause Solution Question AnswerMaintenance Error messagesSpecifications To clean this unit, wipe with a soft, dry clothLimited warranty only for U.S.A Panasonic/Technics DJ Products Limited WarrantyElectric Corporation of America Puerto Rico, Inc. PSC