Siemens AX72 manual Getting started, Using the SIM card/battery, Charge battery

left page (6) of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)

VAR	Getting started		phone 6, then press downwards 7
Language:en;
	6	Getting started
VAR			Insert the battery sideways into the
	Using the SIM card/battery		until it engages.
issue
	Your phone's display is delivered with a		7
date:	protective film. Remove this film before get-
	ting started. The service provider supplies		6
050613	you with a SIM card on which all the im-
	portant data for your account is stored. If
	the SIM card is credit card-sized, snap out		8
	the smaller segment and trim any rough
	edges.			8
	Press depression 1 to remove the		To remove, press the retaining tab
			then lift the battery out.
	cover downwards in the direction of the
	arrow 2.		Place cover on phone and push to the
		1	upper edge, until it clicks into place		9	.

9

2

_Pegasus_DTC\out-

Insert SIM card 3 and push it fully into the locating slot (make sure the angled corner is in the correct position 4).

5

3

4

To remove the SIM card push the card here 5.

Always switch off phone before removing the battery!

Only 3V and 1.8V SIM cards are support- ed. Please contact your service provider if you have an older card.

Charge battery

The battery is not fully charged when de- livered. Plug charger cable into the bot- tom of the phone, plug power supply unit into a mains power socket and charge for at least two hours. The power supply unit heats up when used for long periods. This is normal and not dangerous.

© Siemens AG 2003, C:\Daten_itl\Siemens\DTP-Satz\Produkte\AX72