Siemens AX72 manual Switch on/off, PIN, Enter PIN, Emergency number SOS

right page (7) of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)

Switch on/off, PIN 7

VAR Language:

© Siemens AG 2003, C:\Daten_itl\Siemens\DTP-Satz\Produkte\AX72_Pegasus_DTC\out-

When charging is in progress his displayed.

Charging time

An empty battery is fully charged after about 2 hours. Charging is only possible within a temperature range of

+5 °C to +40 °C. If the temperature ris- es/falls 5 °C above/below this, the charge symbol flashes a warning. The mains voltage specified on the power supply unit must not be exceeded (Operating time, p. 35).

Charge icon not visible

If the battery has been discharged fully the charge icon is not immediately visible when the power supply unit is plugged in. It will appear after up to two hours. In this case the battery is fully charged after 3-4 hours.

Only use the power supply unit provided! Display while in service

Charge level displadgy uring operation

(empty - full):.

A beep sounds when the battery is nearly empty. The charge level of the battery is only displayed correctly after an uninter- rupted charging/discharging cycle. You should therefore not remove the battery un- necessarily and where possible not termi- nate the charging process early.

Switch on/off, PIN

Switch on/off

Press and hold the On/Off/End key B to switch on or off.

Enter PIN

The SIM card can be protected with a 4- to 8-digit PIN.

Enter the PIN using the number keys. The characters **** appear to ensure no- body can read your PIN on the display. Correct errors with §Clear§.

Confirm your input with §OK§. Logging on to the network will take a few seconds.

Emergency number (SOS)

Only to be used in real emergencies!

By pressing the soft key §SOS§ you can make an emergency call on any network without a SIM card and without entering a PIN (not available in all countries).

Switching on your phone for the first time

Time/date

Set the clock to the right time once at start-up.

Press §Yes§. First enter the date (day/month/year), then the time

(24 hours, including seconds). Press §OK§. The time and date are updated.

If the battery is removed for longer than 30 seconds, the clock will be reset.

Time zones

Set the time zone for your area.

Select the required time zone from list with G. Apply with §Set§.

en; VAR issue date: 050613