RCA RV-9978, RV-9968 manual Connecting Auxiliary Components, Before YOU Connect

Page 11

CONNECTING AUXILIARY COMPONENTS

 

ANTENNA

 

 

 

 

 

 

 

 

 

 

 

 

FM

 

 

 

 

 

 

 

 

 

 

 

 

 

 

VIDEO

 

 

 

 

 

 

 

 

 

 

 

VCR

MONITOR

 

 

 

 

 

 

 

 

 

IN

OUT

OUT

 

 

 

 

 

 

 

AM

 

 

 

 

 

 

 

 

 

 

 

LOOP

 

 

 

 

MAINSPEAKERS (8Ω)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

+

R

-

-

L

+

TV

CD

TAPE

 

 

VCR

 

 

 

 

 

 

IN

IN

IN

OUT

IN

OUT

 

 

 

 

 

 

L

 

 

 

 

 

SUB

 

 

 

 

 

 

 

 

 

 

 

WOOFER

 

 

 

 

 

R

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

+

R

-

-

L

+

 

 

AUDIO

 

 

 

 

REAR SPEAKERS (16

Ω)

 

 

 

 

 

 

 

 

 

 

 

 

AC-120V 60Hz

CENTER

SPEAKER(8 Ω)

-+

BEFORE YOU CONNECT...

Protect components from power surges.

Connect all components before plugging any power cords into the wall outlet.

Always turn off the receiver and/or components before you connect or disconnect any cables.

Always make sure the color-coded plugs match the color of the terminals in which they are inserted. The connection cable plugs and jacks are color- coded as follows:

Speaker Terminals Red for positive (+) terminals. Black for negative (-) terminals.

RCA Phono Type Terminals Red for the right (R) channel. White for the left (L) channel.

Yellow for the video (V). Black for the subwoofer. (Not Included)

Some units may be supplied with connection plugs that are color coded red and black

instead of red and white. In this case, the black plug takes the place of the white plug.

Contact Consumer Relations if you have questions concerning the connections or components.

POSITION CABLES CORRECTLY TO AVOID AUDIO HUM OR INTERFERENCE

Insert all cable plugs firmly into their jacks.

Place audio/video cables to the sides of the receiver’s back panel instead of straight down the middle after you connect the components.

Try not to coil any power cables and keep them away from the audio/video cables as

much as possible.

Make sure all antennas and cables are properly grounded. Refer to the Safety Tips sheet packed with your receiver.

PROTECT YOUR COMPONENTS FROM OVER- HEATING

Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.

Do not stack components directly on top of each other.

Allow adequate ventilation when placing your components in a stand.

Place an amplifier near the top shelf of the stand so heating air rising from it will not

flow around other components. If you have a satellite receiver, you should place it on

the top shelf.

11

Image 11
Contents Users Guide For Your Records For Your SafetyService Information Federal Communications Commission FCC InformationTable of Contents Basic Connections First Things FirstUnpack the Receiver Setting UP for Surround Sound CONNECTING, Placing & Balancing the SpeakersConnecting the Wires Subwoofer Sample SET UP for Surround Sound EnjoymentBalancing Your Speakers Using Headphones Connecting AntennasConnecting for Power General Controls Receiver Controls & OperationsDisplay Messages Tuning the ReceiverTuning Auto TuningTo USE Swap Audio Using Swap AudioTo Play a Preset Station Preset ScanningProtect Your Components from OVER- Heating Connecting Auxiliary ComponentsBefore YOU Connect Connecting Complimentary Components Connecting a Satellite ReceiverConnecting a Passive Subwoofer Connecting a Compact Disc PlayerConnecting a Tape Deck Ultimate Connection Connecting Your SATELLITE/CABLE ReceiverConnecting Your VCR to the Receiver When YOU’RE ALL Connected Connecting Your Receiver to Your TVReceiver Controls Using the Universal Remote ControlBattery Installation Basic ControlsVCR Controls Surround Sound Level ControlsRECEIVER/TUNER Controls TV ControlsCD Player Controls DVD Player ControlsSatellite Receiver Controls Programming the Remote to Control a TV Programming Universal RemoteTape Deck Controls Laserdisc Player ControlsProgramming the Remote To Control a Laserdisc Player Programming the Remote to Control a VCRProgramming the Remote to Control AN Audio Component Programming the Remote to Control a Cable BOXProgramming the Remote To Control a Satellite Receiver Programming the Remote to Control a DVD PlayerProgramming the Remote To Control AN RCA Brand DSS Receiver AOC Remote TV CodesRemote VCR Codes Audio Codes Audio & Cable CodesEquipment Specifications Care and MaintenanceTroubleshooting Tips Cleaning the ExteriorIndex SymbolsFor how long after your purchase Limited WarrantyCanadian Service Guia DEL Usuario Para SUS Archivos Informacion LA Comision Federal DE ComunicacionesPara SU Seguridad Información DE ServicioIndice Conexiones Básicas IntroducciónDesembale DEL Receptor INSTALA-CIÓN Para Sonorización Periférica CONEXIÓN, Posición Y Ajuste DE LOS AltavocesConexión DE LOS Cables Altavoz Para Sonidos Subgraves Equilibrio Acústico DEL Sistema DE AltavocesUtilización DE LOS Audífonos Conexión DE LAS AntenasConexión a LA Fuente DE Alimentación Controles Generales Controles Y Funcionamiento DEL ReceptorSintonización Automática MensajesSintonización DEL Receptor SintonizaciónBarrido Programado Cambio DE AudioProgramación DE Emisoras EN LA Memoria Para Escuchar UNA Emisora ProgramadaProtección Contra EL Sobrecalentamiento Conexión DE LOS Componentes AuxiliaresAntes DE Hacer LA Conexión Conexión DE LOS Componentes Complementarios Conexión DE UN Receptor Para SatéliteConexión DE UN Altavoz Para Subgraves Pasivo Conexión DE UN Lector DE Discos CompactosConexión DE UNA Grabadora Segundo Paso Conexión DEL VCR AL Receptor Ultima ConexiónPrimer Paso Conexión DEL RECEP- TOR DE CABLE/SATÉLITE FIN DE LAS Conexiones Tercer Paso Conexión DEL RecepTOR AL Televisor Controles DEL Receptor Control Remoto UniversalInstalación DE LAS Pilas Controles BásicosControles DEL Televisor Controles DE LOS Niveles DE Sonorización PeriféricaControles DEL Receptor Sintonizador Controles DEL Lector DE Discos Compactos Controles DEL VCRControles DEL Receptor DE Satélite Controles DEL Lector DE Discos Digitales DE Video DVDProgramación DEL Control Remoto Para Controlar UN VCR Programación DEL Control Remoto UniversalControles DE LA Grabadora Programación DEL Control Remoto Para Controlar UN TelevisorControl Remoto Universal Remoto del receptor DVD Remoto Codigos Para EL Control Remoto DE TV Codigos Para EL Control Remoto DEL VCR Códigos DE Audio Codigos Para Audio Y Cajas DE CableEspecificaciones Técnicas CuidadoConsejos Para LA Detección DE Fallas Dolby 3 Stereo Dolby PRO Logic Indice TemáticoVigencia de la garantía Garantía LimitadaThomson Consumer Electronics, Inc

RV-9978, RV-9968 specifications

The RCA RV-9978 and RV-9968 are both notable models in the realm of vintage television receivers, showcasing the technological advancements of their era. Designed and manufactured by RCA, these models reflect the company's commitment to quality and innovation in television technology during the 1970s and 1980s.

The RCA RV-9978, known for its striking aesthetics and robust design, is a color television that attracted a lot of attention due to its high-quality picture and sound. One of its main features is the 25-inch screen, which offered a vibrant display that drew viewers into the experience of their favorite shows and movies. The RV-9978 incorporates advanced color fidelity technology, providing enhanced color reproduction that was ahead of its time. Furthermore, the model features a built-in tuner capable of receiving both UHF and VHF signals, allowing users to enjoy a wide array of channels.

In terms of audio, the RV-9978 includes integrated stereo speakers that deliver rich sound quality, giving a more immersive experience. It also boasts a remote control feature, which, during its release, was considered a breakthrough innovation. The design includes easily accessible controls for channel selection and volume adjustment, enhancing user experience and functionality.

On the other hand, the RCA RV-9968 is often celebrated for its compact design and portability. This model is geared towards users seeking flexibility, as it combines a smaller screen size, typically 19 inches, with lightweight construction. The RV-9968 maintains excellence in picture quality and sound output, ensuring viewers do not sacrifice performance for convenience. Like the RV-9978, it also supports both UHF and VHF signals.

Additional characteristics of the RV-9968 include a front-loading cassette, enabling users to play videos directly from tapes, a sought-after feature at the time. Its simplicity in navigation and user-friendly interface appeals to a broad audience, making it a popular choice for families and casual viewers alike.

Both models epitomize RCA's technological prowess during their period, with features reflecting a blend of practicality, innovation, and attention to quality. Collectively, the RV-9978 and RV-9968 stand as testaments to RCA’s influence on television technology, influencing future designs and setting standards that would be echoed in modern devices.