Kyocera E1100 manual Get Started, Phone Battery, Install the Battery, Charge the Battery

1 Get Started

Phone Battery

Install the Battery

To install the battery:

1.Hold the phone face down.

2. Find notch directly above the back cover. It is square. Use the notch to slide the cover down. Lift the cover from the bottom to remove.

3. Place the battery in the battery casing with the metal contacts facing toward the bottom of the phone. The metal contacts of the battery must make contact with the metal contacts of the battery casing.

4.Replace the battery door by sliding the

notches into the openings on each side of the battery casing.

5.Snap the cover into place.

Charge the Battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1.Connect the AC adapter

to the micro USB jack on the side of the phone.

2.Plug the adapter into a wall outlet.

The battery icon in the

upper-right corner of the screen tells you whether the phone is:

–Charging (the icon is animated)

–Partially charged

–Fully charged

You can safely recharge the battery at any time, even if it has a partial charge.

Warning: The battery will not charge if you use the phone while it is connected to an AC adapter. Note: Before removing the battery, make sure the phone is powered off.

User Guide 9