Ecom Instruments Ex-CDMA 02 manual Radio frequency RF energy

Page 15

below deck on boats

transfer or storage facilities for fuel or chemicals

vehicles using liquefied petroleum gas, such as propane or butane

areas where the air contains chemicals or particles such as grain, dust, or metal powders

any other area where you would normally be advised to turn off your vehi- cle engine

Expection:

This device is allowed to use in areas according the following Norm:

Hazardous areas

Class I Div. 2 A-D T6

Ta = -22°F ... + 140°F

Use with care

Use only in normal position (to ear). Avoid dropping, hitting, bending, or sitting on the phone.

Keep phone dry

If the phone gets wet, turn the power off immediately and contact your dealer. Water damage may not be covered under warranty.

Resetting the phone

Attention not allowed in hazardous areas!

If the screen seems frozen and the keypad does not respond to keypresses, reset the phone by completing the following steps:

1.Remove the battery door.

2.Remove and replace the battery. If the problem persists, return the phone to the dealer for service.

Accessories

For the Ex-CDMA 02 are no accessories approved at the moment. Use only ecom approved accessories with ecom phones.

For further information visit: www.ecom-ex.com

Radio frequency (RF) energy

Your telephone is a radio transmitter and receiver. When it is on, it receives and sends out RF energy. Verizon‘s network controls the power of the RF signal. This power level can range from 0.006 to 0.6 watts.

In August 1996, the U.S. Federal Communications Commission (FCC)

14

Image 15
Contents Non-Incendive Cell Phone Ex-CDMA Table of Contents Page Application Safety informationFaults and damage Safety regulationsEx-Data SpecificationsStorage temperature 22 to +140F -30 to +60C Cleaning, maintenance and storageCertificate of Compliance Page Page Page Warranty and Liability Kyocera is a registered trademark of Kyocera User Guide for the ecom Ex-CDMA 02 PhonePage Page Page August 1996, the U.S. Federal Communications Commission FCC Radio frequency RF energy2V DC 0.6A Getting Started Important Screen goes blank Turn the phone off Press and holdPage SID Page Making and Answering Calls Page Page Page Page Page Page Setting Call Guard to avoid roaming calls Entering LETTERS, NUMBERS, and Symbols Entering words quickly Information, see Enter a number Use Choose Lowercase the next letterChoose Storing Contacts Down to highlight the phone number you want to edit To call the contact, highlight the number and press Mobile Pager FaxSending and Receiving Text Messages To select Insert Page If you cannot send messages Understanding appended messagesImportant You will be charged for each message segment To activate Direct View Select Done Page Page Customizing Your Phone Disappears. The phone will now ring for incoming calls Page Adjusting the backlighting Page Page Page Page Data settings Setting Com port speed Using Voice Recognition Phone responds „Say a name Read the message and press Press to add an event to a selected date Using ToolsClear the value currently stored in memory Media Gallery Saving memory GET IT NOW About Get It Now Opening an application Information can be obtained by pressing to open System Info Connecting to the Internet Using Mobile WebPress to select Yes to enable security Disabling an applicationGetting Help Customer Support Page Copyright 2008 ecom instruments GmbH