Menu | ATI Technologies QA-341, QA-342 instruction

Chapter 4 Menu

3.Connect the larger plug on the USB to mini-USB cable to an available USB port on your PC (the red charging LED on your WiFi phone should light up when both ends of the cable are connected).

4.Press the “Menu” softkey on your WiFi phone.

5.Use the navigation key to scroll down to “Phone Settings” and press the “Select” softkey.

6.Use the navigation key to scroll down to “Firmware Upgrade” and press the “Select” softkey.

7.Your WiFi phone’s screen should display “Phone must be connected to computer. Phone will now power down.” Press the “Continue” softkey. Your WiFi phone should turn off, and it should remain turned off while you are installing the USB drivers.

8.After a moment, Windows should prompt you with a dialog box indicating that it has found a new hardware device. Follow the on-screen instructions to install the USB driver. IMPORTANT: Do not let Windows search for the driver. Manually locate the correct driver yourself. Use the Windows dialog boxes to browse to the location on your PC where you unzipped the MIP.INF and MIP.SYS files and select “OK” or “Next”. If Windows displays a warning that the driver is unsigned, tell it to go ahead with the installation.

9.After a few moments, Windows should indicate that the installation of the USB driver is complete.

Step 3, Updating the Firmware:

1.If the mini-USB cable is connected to the bottom of your WiFi phone, disconnect it. (The red charging light on your WiFi phone should turn off.)

2.Turn on your WiFi phone, and allow it to finish starting up (your WiFi phone should have been powered down in Step 2.7 above).

in the United States and/or other countries.