Sharp CD-DP900E operation manual Enhancing your system, Troubleshooting chart, CD player, Tuner

Page 28
AUX sockets.
When using video equipment, connect the audio output to this unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the VIDEO/AUX button.
4 Play the connected equipment.
Note:
To prevent hum interference, place this unit away from a television.
￿ To record on a tape
1 Insert a cassette in the TAPE 2 cassette compartment.
2 Press the VIDEO/AUX button.
3 Press the REC PAUSE ( ) button.
4 Press the / (TAPE 2 ) button.
5 Play the VCR, DVD, etc.
Use a connection lead to connect the VCR, DVD, etc. to the VIDEO/
1
Red White
RCA lead
(not supplied)
￿ Listening to the playback sounds from
VCR, DVD, etc.

CD-DP900E

Advanced Features/References

- Enhancing your system / Troubleshooting chart -

 

 

Enhancing your system

The connection lead is not included. Purchase a commercially available lead as shown below.

VCR, DVD, etc.

To the line output sockets

White Red

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service tech- nician.

If something is wrong with this product, check the following before calling your author- ised SHARP dealer or service centre.

￿ General

Symptom

Possible cause

The clock is not on time.

Did a power failure occur? Reset the

￿

clock. (Refer to page 15.)

 

 

When a button is pressed, the unit

Set this unit to the power stand-by mode

does not respond.

and then turn it back on.

 

If the unit still malfunctions, reset it. (Refer

￿

to page 29.)

 

 

No sound is heard.

Is the volume level set to "0"?

￿Are the headphones connected? Are the speaker wires disconnected?

￿ CD player

Symptom

Possible cause

Playback does not start.

Is the disc loaded upside down?

Playback stops in the middle or is

Does the disc satisfy the standards?

￿not performed properly.

Is the disc distorted or scratched?

 

 

Playback sounds are skipped, or

Is the unit located near excessive vibra-

stopped in the middle of a track.

tions?

￿Is the disc very dirty?

Has condensation formed inside the unit?

￿Tuner

￿

Symptom

Possible cause

 

 

 

 

Radio makes unusual noise con-

Is the unit placed near the TV or compu-

 

secutively.

￿ter?

 

 

Is the FM aerial or AM loop aerial placed

 

 

properly? Move the AC power lead or the

 

 

unit away from the aerial if located near.

 

 

 

28

02/1/9 CD-DP900E(UK)_3.fm

Page 27 Page 29
Image 28
Page 27 Page 29
Contents CD-DP900E Special notes Special notesContents Precautions Volume controlCal Sharp service facility GeneralAccessories General Information Precautions / AccessoriesRemote control AM loop aerial FM aerial Care of compact discsControls and indicators IndicatorsFront panel ControlsSleep Indicator AC Power Lead Transport ScrewDisplay Rear panelInformation and indicators Full-Range Speaker Speaker WireFront speaker Centre speakerCD Random Button CD Clear ButtonCD Track Up or Fast Forward Button Aerial connection System connectionsRemoving the transport screw Speaker connection Placing the speaker systemHeadphones Make a hole in the wall using aPreparation for Use System connections DrillRemote control Demonstration modeTo turn the power on Battery installationExtra bass X-BASS/Pre-programmed CD-DP900ESound controlEqualiser Setting the clock Basic Operation Setting the clockTo readjust the clock To confirm the time displayListening to a CD CDs CD Playback Listening to a CD CDsTo locate the desired portion To locate the beginning of a trackStarting playback with a desired track Random play Repeat playProgrammed play Tuning Auto tuningListening to the radio Radio Listening to the radioTo scan the preset stations To erase entire preset memoryPreset channel Tuning SeeListening to a cassette tape Tape 1 or Tape Tape Playback Listening to a cassette tape Tape 1 or TapeFast forward/rewind Tape 2 only Press the Tape buttonRecording from a CD CDs Recording to a cassette tapeTape Recording Recording to a cassette tape Recording from the radio Dubbing from tape to tapeErasing recorded tapes Press the / Tape 2 button to start dubbing To stop dubbingAdvanced Features Enjoy the surround sound Phantom modeEnjoy the surround sound Normal mode To balance the front speakersTimer playback or timer recording Timer and sleep operationAdvanced Features Timer and sleep operation Sleep operation Troubleshooting chart Enhancing your system / Troubleshooting chartEnhancing your system CD playerRemote control Clearing all the memory resetCassette deck CondensationMaintenance SpecificationsCleaning the tape-handling parts Cleaning the cabinetSpecifications Surround speakerTerms of Guarantee A0201.HK
Top Page Image Contents