MAINTENANCE
CONSOLE TROUBLE-SHOOTING
If the console does not function properly, the batteries should be replaced. To replace the batteries, see assembly step 5 on page 6. In addition, make sure that the extension wire is plugged into the console. (See assembly step 1 on page 5.)
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the Side Shield (27) must first be removed. Remove the 5/16Ó x 3/4Ó Tap Screw (18) from the left Crank Arm (10). Slide the left Crank Arm off the Crank Shaft (11). Remove the right Crank Arm (not shown) in the same way.
Top |
|
| 27 |
| Back |
10 |
|
18 | 11 |
42 |
|
Remove the three #8 x 3/4Ó Tec Screws (42) from each side of the Side Shield (27).
Hold the Side Shield (27) near the back and pull it apart slightly until the Side Shield can be lifted off the ends of the Crank Shaft (11). Remove the Side Shield.
Do not pull the Side Shield apart at the top or the seam may be broken.
Next, locate the
Reed Switch (48).
Turn the Pulley
(19)until the Magnet (55) is
aligned with the | 55 |
Reed Switch. | 51 |
Loosen, but do | 48 |
not remove, the |
|
#10 x 1/2Ó Tec | 19 |
Screw (51). Slide |
|
the Reed Switch |
|
slightly closer to or farther away from the Magnet. Make sure that the Magnet will not hit the Reed Switch. Retighten the Tec Screw. Turn the Pulley for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shield and the crank arms.
HOW TO ADJUST THE RESISTANCE STRAP
If the pedals do not have enough resistance, even when the resistance knob is turned to the maximum setting, the Resistance Strap (31) may need to be adjusted. To adjust the Resistance Strap, the side shield must first be removed. Refer to the instructions at the left to remove the side shield.
Turn the resistance knob to the lowest setting. (See
HOW TO ADJUST THE RESISTANCE OF THE PEDALS on page 7.) Grip the end of the Resistance
Strap (31) and |
|
pull it away from |
|
the rest of the |
|
Strap. Next, pull |
|
the end of the |
|
Strap up to |
|
remove any | 31 |
slack. Then press |
|
the end of the |
|
Strap against the |
|
rest of the Strap |
|
as shown. Turn |
|
the pulley for a |
|
moment to make sure that there is not too much resistance. When the Resistance Strap is properly adjusted, reattach the side shield and the crank arms.
10