HOW TO ADJUST THE DRIVE BELT
If the Drive Belt (32) slips as you exercise on the ECLIPSE II, the Drive Belt should be adjusted. To adjust the Drive Belt, the side shield must first be removed. Refer to the instructions on page 10 and remove the side shield.
Next, loosen the |
| |
two 3/8Ó Nylon | 20 32 | |
Jam Nuts (23) | 26 | |
(there is one on | ||
| ||
each side of the |
| |
Flywheel [20]). |
| |
To tighten the | 23 | |
Drive Belt (32), | ||
turn the two |
| |
1/4Ó Nylon |
| |
Locknuts (26) |
| |
clockwise; to |
|
loosen the Drive
Belt, turn the Nylon Locknuts counterclockwise. Make sure that the Flywheel is straight and retighten the 3/8Ó Nylon Jam Nuts (23). When the Drive Belt is properly adjusted, reattach the side shield and the crank arms.
11