3.Slide a Handlebar Spacer (46) onto the left axle on the Upright (2). Make sure that the open side of the Handlebar Spacer is facing the Upright. Next, make sure that there are two Handlebar Bushings (40) in the Left Handlebar (6). Slide the Left Handlebar onto the left axle on the Upright. Tap a 5/8Ó Axle Cap (45) onto the axle.
Repeat this step to attach the Right Handlebar (not shown).
4.Make sure that there are two Pedal Leg Bushings
(39)in the left Pedal Leg (3). Apply a small amount of grease to a Pedal Bolt (8). Insert the Pedal Bolt into the left Pedal Leg and slide a Crank Spacer (41) onto the Pedal Bolt. Tighten the Pedal Bolt into the left Crank Arm (10), but do not overtighten it. You should be able to turn the Crank Spacer with some effort. Tighten a 1/2Ó Nylon Jam Nut (9) onto the Pedal Bolt.
Repeat this step to attach the right Pedal Leg (not shown).
5.The Console (52) requires two ÒAAÓ batteries (not included). Alkaline batteries are recommended.
To install batteries, first slide up the Battery Cover (60) and carefully remove the battery clip from the Console (52). Insert two batteries into the battery clip as shown.
Make sure that the negative ends of the batteries (marked ÒÐÓ) are touching the springs in the battery clip. Replace the battery clip and close the Battery Cover.
3 |
|
| 6 |
| 2 |
45 |
|
| 46 |
| 40 |
4 |
|
| 9 |
3 | 10 |
| |
| 41 |
| 39 |
| 8 |
5 | Batteries |
| |
| 60 |
| Battery |
| Clip |
| 52 |
6.Make sure that all parts of the ECLIPSE II are properly tightened. To protect the floor or carpet from damage, place a mat under the ECLIPSE II.
6