Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a Phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14. The second number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is missing, call toll-free1-866-699-3756.

M6 Nylon	M10 Nylon	M10 Split	Wave Washer	M10
Locknut (27)–4	Locknut (33)–6	Washer (59)–2	(64)–2	Washer (35)–2

M4 x 16mm	M6 x 48mm Flat Head	M10 x 25mm
Screw (42)–5	Screw (36)–4	Patch Screw (22)–2
M6 x 38mm Button Bolt (50)–4	Pedal Arm Bolt Set (40)–2

M10 x 66mm Button Bolt (48)–2		M10 x 72mm Carriage Bolt (34)–4
1. Identify the Front Stabilizer (10), which is narrower than	1
the Rear Stabilizer (not shown). While another person	1	34
lifts the front of the Frame (1), attach the Front		34
Stabilizer to the Frame with two M10 x 72mm Carriage
Bolts (34) and two M10 Nylon Locknuts (33).
		10	1
			1
			33
4