8.Apply a small amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) onto the axle, and place a Wave Washer (64) on the end of the axle. Next, slide an M10 Washer (35) onto an M10 x 25mm Patch Screw (22), and tighten the Patch Screw into the axle.
Hold the lower end of the left Handlebar Arm (5) inside of the bracket on the Left Pedal Arm (11). Next, apply grease to a Pedal Arm Bolt Set (40). Attach the Left Pedal Arm to the left Handlebar Arm with the Bolt Set.
Do not overtighten the Bolt Set; the Handlebar Arm must pivot freely.
Attach the Right Pedal Arm (not shown) to the right side of the elliptical exerciser in the same way.
See step 5. Tighten the M10 x 66mm Button Bolts (48). See step 6. Tighten the M6 x 38mm Button Bolts (50) in the Handlebar Arms (5).
8 |
|
|
| 5 |
|
| Grease | |
Grease | 40 | 16 |
| ||
40 | 11 | 35 64 |
| 22 | |
9.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip- tical exerciser.
7