Outdoor Antenna
Outdoor antennas are subject to weathering that can reduce signal quality. Inspect the antenna and
| Combination |
|
| VHF/UHF Antennas | |
| 300 Ohm |
|
| Flat Wire |
|
| 75 Ohm | 75 Ohm |
| Terminal | Coaxial Cable |
300 to 75 | on Treadmill |
|
Ohm Adapter |
| 75 Ohm CATV Cable |
|
| |
300 Ohm Flat Wire
1.Refer to the drawing above. Connect the 300 ohm flat wire to the 300 ohm to 75 ohm adapter.
2.Push the end of the 300 ohm to 75 ohm adapter into the 75 ohm antenna terminal on the treadmill. (See assembly drawing 5 on page 8 to find the lo- cation of the terminal.)
75 Ohm Coaxial Cable
Refer to the drawing above. Connect the 75 ohm coax- ial cable directly to the 75 ohm antenna terminal. (See assembly drawing 5 on page 8 to find the location of the terminal.)
CATV CABLE CONNECTION
1.Remove the VHF 300 to 75 ohm adapter or the VHF cable from the antenna terminal. (See assembly draw- ing 5 on page 8 to find the location of the terminal.)
BASIC TV OPERATION
Read the important precautions on pages
3 to 5 of this manual. Before operating the TV,
make sure that the on/off switch located near the power cord is in the ÒonÓ position. In
addition, make sure that the power cord is properly plugged in (see page 9).
Turning on the Power
To turn on the TV, press the POWER button on the TV.
Volume Control
To adjust the volume to the desired level, press the VOLUME + or Ð button.
The sound level will be shown by a bar on the TV screen. As the sound level is increased, the bar will move
to the right. As the soundVOLUME level is decreased, the bar
will move to the left. Note: If no broadcasting signal is re-
ceived, the sound will be muted and the volume control will be disabled.
Skip Mode
Press the CHANNEL ▲ or ▼ button to select memo- rized channels, skipping over empty channels. Hold down the CHANNEL ▲ or ▼ button to change channels continuously. Note: If no channels are memorized, the TV will switch to the SEARCH mode.
Search Mode
Press the CHANNEL ▲ or ▼ button to search for the next available channel. Hold down the CHANNEL ▲ or
▼button to search through all available channels.
2.Connect the CATV cable (75 ohm coaxial cable) to the 75 ohm antenna terminal on the treadmill.
75 Ohm CATV Cable
VHF 75 Ohm Jack
Note: Before selecting channels with the CHANNEL ▲ or ▼ button, the channels must be set into the TVÕs memory. See MEMORIZING CHANNELS on page 14.
13