The lower left display
can show the elapsed time and the distance that you have walked or run during your
workout. Also, each
time you change the incline, the display will show the incline setting for a few seconds. Note: When a program is selected, the display will show the time remaining in the program instead of the elapsed time. When a distance goal program is selected, the display will show the number of kilometers re- maining in the program instead of the distance that you have walked or run.
The lower right display can show the speed of the walking belt and the approximate number of calo- ries that you have burned during your workout.
This display will also show your heart rate when you use the handgrip pulse sensor (see step 7).
The upper display can
show the distance that you have walked or run, the approximate num- ber of calories you have
burned, the speed of the
walking belt, or the workout time. Press the Display button repeatedly until the upper display shows the information that you are most interested in viewing.
Note: While information is shown in the upper dis- play, the same information will not be shown in the lower left or lower right display.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
7.Measure your heart rate if desired.
Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean.
To measure your heart rate, stand on the foot rails
and place your hands on the metal contacts— avoid moving
your hands. When your pulse
is detected, the heart symbol in the display will begin to flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.
8.Turn on the fan if desired.
The fan features low and high speed settings. Press the Fan button repeatedly to select a fan speed or to turn off the fan. Note: If the fan is on when the walking belt is stopped, the fan will turn off automatically after a few minutes.
9.When you are finished exercising, remove the key from the console.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when you fold the treadmill to the storage posi- tion, or you may damage the treadmill. Next, re- move the key from the console and put it in a secure place.
When you are finished using the treadmill, switch the reset/off circuit breaker to the “off” position and unplug the power cord. IMPORTANT: If you do not do this, the treadmill’s electrical compo- nents may wear prematurely.
13