Weslo WLTL39907.0 Attach the other Handrail Bracket to the left, Nected PROPERLY, the Console MAY

5. Insert the tab on one of the Handrail Brackets	5
(5) into the slot in the right Upright (69). Attach
			69
the Handrail Bracket with a 3/4" Screw (2).
Attach the other Handrail Bracket to the left			Slot
Upright (not shown) in the same way.
			Tab
			5
			2
6. Set the Console (43) face-down on a soft sur-	6
face to avoid scratching the Console. Next, hold
a Handrail (71) near the console wire. Insert the
console wire into the hole in the side of the
Handrail. Grasp the tie and pull the console wire			Tie
out of the hole in the top. Then, attach the			2
			71
ground wire to the Handrail with a Silver Ground
			2
Screw (96).
Set the Handrail (71) on the Console (43).			2
	Console Wire
Attach the Handrail with three 3/4" Screws (2).
			Ground Wire
Make sure that the console wire is not
pinched. Start all three Screws before tight-
ening any of them; do not overtighten the
Screws. Insert the excess ground wire back into	43		96
the opening in the Console.
Attach the other Handrail (not shown) to the
Console (43) as described above. Note: There
are no wires on the other side.
7. Remove the tie holding the Wire Harness (42) to	7	43
the right Upright (69). With the help of a second
person, hold the Console (43) near the right
Upright.
Remove the tie from the console wire. Connect
the Wire Harness (42) to the console wire. See
the inset drawing. The connectors should
slide together easily and snap into place. If
the connectors do not slide together easily and
snap into place, turn one connector and try			Console
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY			Wire
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors and	42		Console
the excess wire into the right Upright (69).
			Wire
			42
	69
	8