ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires the included hex keys and your own Phillips screwdriver | and needle- | |
nose pliers | . |
|
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: Some parts may be preattached. To avoid damaging parts, do not use power tools for assembly. Extra hardware may be included.
4.2 x 19mm | #10 x 1" Tek | |
Screw | Screw | |
M10 x 45mm Screw | M10 x 65mm Screw | |
1. Make sure that the power cord is unplugged. | 1 | |
| ||
With the help of a second person, carefully tip | 80 | |
the treadmill onto its left side. Unfold the Frame | ||
73 | ||
(50) away from the Upright (73). Do not lean on | ||
the Upright. | 50 | |
| ||
Orient the Base (80) as shown. Attach the Base | 1 | |
to the Upright (73) with four M10 x 65mm Screws | ||
(1). Start all four Screws, and then tighten |
| |
them. |
| |
Raise the Upright (73), so that the Base (80) is |
| |
flat on the floor. |
| |
| 1 | |
| 6 |