7.Set the Console Assembly (91) face down on a soft surface to avoid scratching the Console Assembly. Hold the Right Handrail (33), which has a large hole in one side, near the Console Assembly.
Next, insert the console wire and the tie into the hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail. Then, set the Right Handrail (33) on the Console Assembly (91). Make sure that no wires are pinched. Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail, and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm
Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the Console Assembly (91) in the same way. Note: There are no wires on the left side.
8.Remove the plastic ties from the Right Handrail (33) and the Left Handrail (not shown). If neces- sary, press the Cage Nuts (105) back into place.
With the help of a second person, hold the Console Assembly (91) near the Right Upright (54).
Connect the Wire Harness (39) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and the ex- cess wire downward into the Right Upright (54). Remove the wire tie from the Wire Harness (39).
7 | Console |
|
|
Tie | Wire | 85 |
|
Bracket |
| 7 | 10 |
33 | Large |
| |
|
| ||
| Hole |
|
|
91 |
|
| |
8 |
|
|
|
33 | 91 |
| Console |
|
| ||
105 |
|
| |
Console Wire |
| Wire | |
39 |
|
| |
54 | Wire |
| 39 |
Tie |
| ||
10