Weslo WLTL37308.0 user manual Bolt Head Wire Tie

Page 8

3.Attach each Base Extension (45) to the Base

(52)with two M8 x 58mm Bolts (13), two M8 Flat Washers (32), and two Base Extension Nuts

(43).Note: The heads of the Bolts should be on outside of the Base Extensions.

Lower the Base (52) so that it is flat on the floor.

4.Position the Base (52) as close to the front of the treadmill as possible, as shown.

See the upper inset drawing. Locate the wire tie in the lower end of the Right Upright (54). Tie the wire tie securely around the end of the Wire Harness (39). Then, locate the other end of the wire tie in the upper end of the Right Upright. Pull the upper end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright. Secure the Wire Harness to the Right Upright so that it will not fall inside.

See the lower inset drawing. Press the indi- cated Grommet (49) into the Right Upright (54).

3
			45
Bolt Head	13		43
45	13	32	43
		32
13	43	52
32
4		39	54
39		39	54
54			Wire Tie
54
52
			54
		39	49
			52

8

Image 8

Contents QUESTIONS? Model No. WLTL37308.0 Serial NoMon.-Fri a.m.-6 p.m. MST Sat a.m.-4 p.m. MST On the WEBTable of Contents Important Precautions Page Before YOU Begin For your benefit, read this manual carefully beforeAssembly Make sure that the power cord is unplugged Bolt Head Wire Tie See the left inset drawing. Identify the two Outer side of the Frame Spacer facing Right UprightStar Washer 9 do not fully tighten the Patch Bolt yet See the inset drawing in . IdentifyConsole Tie Wire Bracket Large Hole 105 Console Wire Then, firmly tighten all six Bolts Top View Wires in the Right Upright not shown Same way. Be careful not to pinchPRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltTurn on the fan if desired Measure your heart rate if desiredProximately Contacts Seconds- avoid moving HOW to USE a Preset Workout Information Mode HOW to USE the Crosswalk ArmsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on Walking belt. If the walking belt has shifted toProblem The crosswalk arms squeak during use Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. WLTL37308.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. WLTL37308.0 R0808B Exploded Drawing B-Model No. WLTL37308.0 R0808B Exploded Drawing C-Model No. WLTL37308.0 R0808B Exploded Drawing D-Model No. WLTL37308.0 R0808B Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty