Weslo WLTL37308.0 user manual

Page 4
19. The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.
20. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)
21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6 and HOW TO FOLD AND MOVE THE TREADMILL on page 20.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
22. When folding or moving the treadmill, make sure that the frame is held securely in the storage position.

23. Do not change the incline of the treadmill by placing objects under the treadmill.

24. Inspect and properly tighten all parts of the treadmill regularly.

25. Never drop or insert any object into any opening on the treadmill.

26. This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial,DANGER:rental, or institutional setting.

27.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents QUESTIONS? Model No. WLTL37308.0 Serial NoMon.-Fri a.m.-6 p.m. MST Sat a.m.-4 p.m. MST On the WEBTable of Contents Important Precautions Page Before YOU Begin For your benefit, read this manual carefully beforeAssembly Make sure that the power cord is unplugged Bolt Head Wire Tie See the left inset drawing. Identify the two Outer side of the Frame Spacer facing Right UprightStar Washer 9 do not fully tighten the Patch Bolt yet See the inset drawing in . IdentifyConsole Tie Wire Bracket Large Hole 105 Console Wire Then, firmly tighten all six Bolts Top View Wires in the Right Upright not shown Same way. Be careful not to pinchHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltProximately Contacts Seconds- avoid moving Measure your heart rate if desiredTurn on the fan if desired HOW to USE a Preset Workout Information Mode HOW to USE the Crosswalk ArmsHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Walking belt. If the walking belt has shifted toProblem The crosswalk arms squeak during use Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. WLTL37308.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. WLTL37308.0 R0808B Exploded Drawing B-Model No. WLTL37308.0 R0808B Exploded Drawing C-Model No. WLTL37308.0 R0808B Exploded Drawing D-Model No. WLTL37308.0 R0808B Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT