Weslo WLTL29321 user manual Harness from slipping, Do not overtighten the Screws.Note Make sure

6. Set the Console (10) in the Console Base (46).		Be careful
to avoid pinching any wires.	Insert the excess Wire
Harness (21) into the large hole in the side of the right
Handrail (1). Securely tighten the plastic ties on the
bottom of the Console Base to prevent the Wire
Harness from slipping.	Cut off the ends of the plastic ties.

Attach the Console Base (46) to the Handrails (1) with four 3/4” Screws (13); do not overtighten the Screws.

7.Attach the Console (10) to the Console Base (46) with seven 3/4” Screws (13). Make sure that no wires are pinched. Start all seven Screws before tightening them;

do not overtighten the Screws.Note: Make sure the in-

dicated 3/4” Screw is not overtightened. Overtightening the Screw may cause the Console to not function properly.

8.Attach the Storage Latch (14) to the left Upright (76) with two 3/4” Screws (13). Be careful not to overtighten the

Screws.

Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between
the Handrails (1). Firmly tighten all of the bolts and
screws used in assembly steps 2, 3, and 4.	Then,
lower the frame to the floor.

6	46	10
		1
	Ties
	21	13
13	1
7	46	10

13

Do not overtighten

8

1

76

14

13

9. Make sure that all parts are properly tightened before you use the treadmill.	Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.

7