9.Press the Wire Harness (65) into the indicated track in the Console Base (67). (Note: If there is a cylinder on the Wire Harness that will not fit into the track, press as much of the Wire Harness as possible into the track.) Next, insert the excess Wire Harness into the large hole in the side of the Right Handrail (40). Securely tighten the nylon tie to prevent the Wire Harness from slip- ping, and then cut off the end of the nylon tie.
Attach the Access Door (84) to the Console Base (67) with the 3/4” Screw (38).
See step 5. Tighten, but do not overtighten, the 1” Bolts (43) and the 4” Handrail Bolts (78).
10.Lower the Handrails (13, 40) until they are touching the floor.
See drawing 10a. Position the Handrails (13, 40) so the treadmill Frame (96) is centered between them.
Firmly tighten the four 3” Bolts (58) and the two 4” Frame Bolts (54). Be careful not to overtighten the
Bolts.
11.Remove the knob from the pin. Make sure that the col- lar and the spring are on the pin. Insert the pin into the Latch Housing (46), and then tighten the knob back onto the pin.
12.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be in- cluded. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 18). To protect the floor or carpet, place a mat under the treadmill.
9 | 67 |
|
|
| |
| 40 |
|
| 65 | 84 |
|
| 38 |
| Tie |
|
| Track | |
10 | 40, 13 | 54 |
|
| |
|
| 58 |
| 96 |
|
10a |
|
|
| Top View | |
| 40 | 13 |
| 96 |
|
11 |
|
|
| Knob |
|
|
| Spring |
|
| Collar |
| 46 | Pin |
|
| |
9