Weslo 831.283160 user manual

8.The Console (16) requires three AA batteries (not included); alkaline batteries are recommended. Insert three batteries into the Console as shown. Make sure that the batteries are oriented as shown by the markings inside the Console.

Hold the Console (16) near the Handlebar (15). Insert the console wire down through the indicated hole in the Handlebar. Note: The console wire is longer than shown.

Attach the Console (16) to the Handlebar (15) with four M4 x 16mm Screws (49). Be careful to avoid pinching the console wire.

9.While another person holds the Handlebar (15) near the Upright (13), insert the console wire down through the Upright. Attach the Handlebar to the Upright with three M8 x 15mm Button Screws (34) and three M8 Split Washers (42). Be careful to avoid pinching the console wire. Note: The console wire is longer than shown.

10.While another person holds the Upright (13) in the position shown, connect the console wire to the Reed Switch Wire (43). Next, connect the console cable to the Lower Cable (45) in the following way:

•See drawing A. Pull up on the metal bracket on the Lower Cable (45), and insert the tip of the console cable (CC) into the wire clip inside the metal bracket as shown.

•See drawing B. Firmly pull up the console cable (CC) and slide it into the top of the metal bracket as shown.

•See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.

Push the excess wire and cable down into the Frame (1), and insert the Upright (13) into the Frame. Be care- ful to avoid pinching the wires and cables. Attach the Upright to the Frame with two M8 x 48mm Bolts (59), two M8 Split Washers (42), and two M8 Nylon Locknuts (10).

8	Batteries
16			16
		Hole
	49	15	Console
			Wire
9
	Console
	Wire
			15
34	42	42	34
		13
10		13
	59
		42
	42
Console Wire
	43		10
	1	Console Cable
		45
A	B		C
	Metal		Metal
	Bracket	CC
			Bracket
CC
	45	45

7