ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own rubber mallet 
.
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
| M6 x 15mm | M10 x 50mm Screw |
|
| Screw |
| |
M10 Washer |
|
| |
|
|
| |
|
|
| |
|
| M10 x 55mm Screw |
|
M12 Washer |
| M12 x 60mm Screw |
|
M10 Nut |
| ||
1. Attach the Base Crossbar (44) to the two | 1 |
| |
Upright Bases (16) with two M10 x 50mm |
| ||
16 |
| ||
Screws (15) and two 10mm Washers (14) as |
| ||
15 |
| ||
shown. |
|
| |
| 14 |
| |
|
| 44 | 16 |
|
| 14 |
|
|
|
| 15 |
|
| 4 |
|