See . Tighten the four M10 Nuts Used in step

4. Position the Frame (41) between the Left and	4	3
Right Uprights (3, 9). Attach the Frame to the	4
Right Uprights (3, 9). Attach the Frame to the
Uprights with two M12 x 60mm Screws (11) and		46	23
two 12mm Washers (12).		46	23
two 12mm Washers (12).		12	9
			9
Connect the Upright Wire (46) in the Left Upright		11
(3) to the wire from the Reed Switch (23).
See step 2. Tighten the four M10 Nuts (18)
used in step 2.			12
			12
			11
			18
			41
5. The Console (10) requires one “AA” battery (not	5
included); an alkaline battery is recommended.	5
included); an alkaline battery is recommended.
Remove the battery cover (not shown) and insert			10
a battery; make sure that the negative (–) end		“AA”
of the battery is touching the spring in the		“AA”
of the battery is touching the spring in the		Battery
Console. Then, reattach the battery cover.		Battery
Console. Then, reattach the battery cover.
Slide the Console (10) onto the bracket in the
center of the Handrail (5).
Connect the Handrail Wire (49) to the console			Bracket
Connect the Handrail Wire (49) to the console
wire. Then, insert the excess wiring into the
Handrail (5) and press the Grommet (48) into
the hole in the Handrail.		48	5
			5

			49
6. Remove the knob from the pin. Insert the pin,	6
with the spring, into the Latch Assembly (7) as	6
with the spring, into the Latch Assembly (7) as
shown. Then, tighten the knob onto the pin.
			7
			Knob
		Pin
			Spring

See step 2. Tighten the four M10 Nuts (18)