Weslo WCTL29607.0 HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 17

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight. As you raise the frame, make sure to lift with your legs rather than your back. Raise the frame about halfway to the vertical position.

2.Move your right hand to the position shown and hold the treadmill firmly. Using your left hand, pull the latch knob to the left and hold it. Raise the frame until the catch is past the latch pin. Then, slowly release the latch knob; make sure that the catch is resting against the latch pin.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

Frame

Latch

Pin

Latch

Knob

Catch

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the catch is resting against the latch pin.

1.Hold the handrails and place one foot against one of the wheels. Do not pull back on the frame.

2.Tilt the treadmill backward until it rolls freely on the wheels, and carefully move the treadmill to the desired location.

Never move the treadmill without tipping it backward. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against one of the wheels, and carefully lower the treadmill until it is in the storage position.

Handrail

Wheel

17

Image 17
Contents Call TOLL-FREE QUESTIONS?Model No. WCTL29607.0 Serial No Table of Contents Important Precautions Page Before YOU Begin Assembly Same way See the inset drawing. Locate the wire tiePage Tie Console Wire Connector Bracket Large Hole Make sure that no wires are pinched. Start Power is Turned ON. Insert the conTors are not Connected Properly Console MAY be Damaged When Tighten the Bolts yetTop View PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord HOW to Turn on the Power Console DiagramFeatures of the Console HOW to USE the Manual Mode Select one of the four speed programs HOW to USE a Speed ProgramMeasure your heart rate if desired HOW to Change the Incline of the Treadmill HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Qty Description R0807AModel No Exploded Drawing B-Model No. WCTL29607.0 R0807A Exploded Drawing C-Model No. WCTL29607.0 R0807A Exploded Drawing D-Model No. WCTL29607.0 R0807A Limited Warranty Ordering Replacement Parts