Weslo WCTL29607.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys , and your own Phillips screwdriver ,

adjustable wrench , and needlenose pliers .

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preat- tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.

	16mm Screw		18mm Screw (58)–2 19mm Screw (10)–4
19mm Tek
Screw (26)–6		(85)–2		M8 x 15mm
				Bolt (8)–6

M6 Flat

M5 StarWasher (32)–4M8 x 52mm Bolt (82)–2

Washer (7)–2

M10 Flat

Washer (14)–2

M6 x 58mm Bolt (13)–4

	M8 Nut (46)–2
M8 Star
Washer (5)–6
M8 Flat		M10 x 58mm Bolt (2)–4
Washer (72)–4	M6 Nut (43)–4

M10 Star
Washer (9)–2		M10 x 110mm Bolt (1)–2
1. Make sure that the power cord is unplugged.	1	26
Place a piece of cardboard under the tread-
mill frame to protect the floor during assem-		63
bly.		26	26
		63
Have a second person hold the Base (52) in the			63
position shown.		52	26
Attach six Base Pads (63) to the Base (52) with		26	63
six 19mm Tek Screws (26).
		63
	6