7.Set the Console (91) face down on a soft sur- face to avoid scratching it. Hold the Right Handrail (33), which has a large hole in the loca- tion shown, near the Console.
Next, insert the console wire into the large hole in the side of the Right Handrail (33). Using needlenose pliers, grasp the tie inside the Right Handrail and pull the connector to the hole near the bracket on the Right Handrail. Carefully grasp the connector with the pliers and pull the console wire out of the hole.
8.Set the Right Handrail (33) on the Console (91).
Make sure that the console wire is not pinched. Start a 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail, and then start two 19mm Screws (10) into the Right Handrail. Tighten the 16mm Screw and then tighten the two 19mm Screws; do not over- tighten the Screws.
Attach the Left Handrail (not shown) to the Console (91) in the same way. Note: There is no console wire on the left side.
7 | Tie |
|
|
| |
Console Wire | Connector |
|
Bracket |
|
|
| Large |
|
| Hole |
|
33 |
|
|
91 |
|
|
8 |
|
|
| 85 |
|
Console Wire | 7 |
|
| 10 | |
|
| |
33 |
|
|
91 |
|
|
9