2. Have a second person hold the Base (52) in the | 2 | |
position shown. | ||
| ||
Identify the Left Upright (53) (the Right Upright | Large | |
[54] has a large hole near the lower end). | ||
| Hole | |
Hold the Left Upright (53) so that the two indi- | 2 | |
54 | ||
cated small holes are on top. Attach the Left | ||
| ||
Upright to the Base (52) with two M10 x 58mm |
| |
Bolts (2). Do not tighten the Bolts yet. | 52 | |
| ||
Attach the Right Upright (54) to the Base (52) | 2 | |
Small Holes | ||
in the same way. | ||
|
|
| 53 |
|
3. Slide the two Wheel Housings (45) onto the Base | 3 |
|
|
(52). Attach each Wheel Housing with two M6 x | 32 |
| |
45 |
| ||
58mm Bolts (13), two M6 Flat Washers (32), and | 43 |
| |
two M6 Nuts (43). |
|
|
|
| 13 | 32 |
|
|
|
| |
|
|
| 32 |
|
| 45 | 43 |
|
|
| |
|
| 13 | 32 |
|
|
| |
|
| 52 |
|
4. Remove the bolts and the cardboard packaging | 4 |
|
|
from both sides of the Hood (65). Discard the |
|
| |
|
|
| |
bolts. | 39 | Wire Tie |
|
|
| ||
Position the Base (52) as close to the front of |
|
|
|
the treadmill as possible. |
|
|
|
See the inset drawing. Locate the wire tie in |
| 54 |
|
the Right Upright (54). Tie the wire tie securely | 65 |
|
|
to the connector on the end of the Wire Harness |
|
| |
|
|
| |
(39). Next, pull the opposite end of the wire tie |
| 54 |
|
out of the upper end of the Right Upright, until |
|
| |
|
|
| |
the Wire Harness is routed completely through |
|
|
|
the Right Upright. Secure the Wire Harness to |
| 39 |
|
the Right Upright so that it will not fall inside. |
|
| |
|
| Wire Tie |
|
| 52 |
|
|
| 7 |
|
|