
ASSEMBLY
To hire an authorized service technician to assemble the Incline Trainer, call
Assembly requires two persons. Set the Incline Trainer in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the Incline Trainer walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver
and
wire cutters . For help identifying the assembly hardware, see the hardware drawings below.
| 3/4” Screw | 3/4” Tek Screw |
Washer |
|
|
3/4” Bolt | 1” Bolt | 3” Bolt |
|
1. To protect the floor during assembly, place a sheet | 1 |
| |
of cardboard under the pallet as shown. |
| ||
With the help of a second person, carefully raise the | 110 |
| |
Upright (110) to the position shown. |
|
| |
While the other person holds the Upright (110), firmly |
|
| |
tighten two 1” Bolts (55) into the lower end of the |
|
| |
Upright and the Upright Base (96). |
| 115 | |
Insert the Power Cord (85) through the hole in the |
|
| |
Upright Cover (115). Press the Upright Cover onto the |
|
| |
Upright (110). Make sure that the Upright Cover is |
|
| |
securely held by the clips along the opening in the |
|
| |
Upright. Tighten a 3/4” Screw (66) into the lower end of |
|
| |
the Upright Cover. Be careful not to over tighten the | 55 | 66 | |
3/4” Screw. | 96 | ||
| |||
| Cardboard | 85 | |
|
| ||
| Pallet |
|
6