1.Make sure that the power cord is unplugged.
Have a second person hold the Base (52) in the position shown.
Attach six Base Pads (63) (three are shown) to the Base (52) with six Base Pad Screws (26).
Identify the Left Upright (53), which has two small holes near the upper end. Hold the Left
Upright so the small holes face the direction shown. Attach the Left Upright to the Base (52) with two Upright Bolts (2) and two Upright Washers (14). Do not tighten the Upright
Bolts yet.
Attach the Right Upright (54) to the Base (52) in the same way.
2.With the help of a second person, raise the Uprights (53, 54) so the Base (52) is flat on the floor as shown.
Attach a Wheel (70) to the outer side of the Base (52) with a Wheel Bolt (35) and a Nut (16) as shown. Do not overtighten the Nuts; the
Wheels should turn freely.
Attach the other Wheel (70) to the outerside of the Base (52) in the same way.
Position the front end of the treadmill Frame (51) between the Uprights (53, 54) as shown. Next, lo- cate the long wire inside the lower end of the Right Upright (see the inset drawing). Securely tie the end of the wire to the end of the Wire Harness (39).
Then, pull the opposite end of the wire until the Wire Harness (39) extends from the upper end of the Right Upright (54).
1 |
|
|
|
| 54 |
|
|
| 63 |
| 53 |
| 52 |
|
|
| 26 |
|
|
| 14 |
|
|
| 2 |
| Small |
|
| Holes | |
| 63 |
| |
| 26 |
|
|
| 63 |
|
|
2 | 39 |
| 54 |
| 54 | ||
|
| ||
|
| 39 | |
|
|
| |
| 53 |
| Wire |
51
| 52 | |
16 | 70 | |
35 | ||
|
7