
8. Set the Console Assembly (91) on the Right Upright (54) | 8 |
|
|
|
|
|
and the Left Upright (not shown). Next, start four M8 x |
|
|
|
|
| |
70mm Bolts (3) with four M8.5 Washers (13) and four |
|
|
|
|
|
|
M8 Star Washers (10) (only two of each are shown) into |
| 91 | Slot |
|
|
|
the Right Upright and the Left Upright. Then, tighten all | 54 |
|
|
| ||
four Bolts. |
|
|
| 7 |
| |
Insert the slack in the Wire Harness (98) down into the |
|
|
|
|
| |
Right Upright (54). |
|
|
|
|
|
|
Attach the Console Back (93) to the Console Assembly |
| 98 |
| 93 |
| |
(91) with four M4.2 x 16mm Screws (7). Make sure that |
| 7 | 7 | |||
the Wire Harness (98) is in the indicated slot in the |
|
| 10 |
| ||
Console Back and that no wires are pinched. |
|
| 13 |
|
|
|
|
|
| 3 |
|
|
|
9. Carefully lower the Handrails (55, 56) to the floor. Center | 9 |
|
|
|
|
|
the Frame (51) between the Handrails, and tighten the |
|
|
|
|
| |
four M10 x 58mm Bolts (2) (see step 1). Then, raise the |
|
|
| 51 |
| 2 |
Handrails back to the vertical position. |
|
|
|
| ||
See the inset drawing. Attach the Latch Assembly (102) |
|
|
|
|
|
|
to the Left Upright (53) with two M4.2 x 16mm Screws |
|
|
| 55, 56 |
|
|
(7). Make sure that the Latch Assembly is oriented |
|
|
|
|
| |
as shown. |
|
|
|
|
|
|
See HOW TO CHANGE THE INCLINE OF THE TREAD- |
|
|
|
|
|
|
MILL on page 15. Adjust the incline of the treadmill as |
|
|
|
|
| 53 |
desired. |
|
|
|
|
| |
|
|
|
| 7 |
| 102 |
|
|
|
|
|
|
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 19). To protect the floor or carpet, place a mat under the treadmill.
10