5.Place the Left Handrail (56) on the Console Assembly (91). Attach the Left Handrail to the Console Assembly with two M4.2 x 19mm Screws (4), an M5 x 16mm Screw (5), and an M5 Star Washer (12).
6.Hold the Console Assembly (91) near the Right Upright (54). Touch the Right Handrail (55) to discharge any static.
Insert the end of the Wire Harness (98) into the hole in the bottom of the Right Handrail (55) and out of the large hole in the side. Next, insert the end of the Wire Harness through the two looped plastic ties.
Press the end of the Wire Harness (98) into the indi- cated connector on the back of the Console Assembly (91). See the inset drawing. The end of the Wire
Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and try again. IF THE CONNECTOR IS NOT
INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
7.Insert the slack in the Wire Harness (98) down into the Right Upright (54). Then, tighten the two plastic ties around the Wire Harness and cut off the ends of the plas- tic ties.
5 | 125 |
|
|
|
|
| 56 |
| |
| 4 |
|
|
|
| 91 |
|
|
|
6 | 91 | Connector |
| |
|
| |||
|
|
|
| |
| 54 |
| Plastic | 98 |
|
|
| ||
| 55 |
| Ties |
|
|
|
| 98 | |
|
|
|
| |
7 |
|
|
|
|
| 54 | 98 | Plastic |
|
|
|
| ||
|
| Ties |
| |
9