Weslo 30863 user manual Problem Solution, Walking belt slows when walked on

PROBLEM:

SOLUTION:

PROBLEM:

SOLUTION:

The walking belt slows when walked on
a. Use only a single-outlet surge suppressor that meets all the specifications described on page 11.
b. If the walking belt is overtightened, treadmill perfor-	b
mance may decrease and the walking belt may be-		2–3 in.
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the hex key, turn both rear
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to 8
cm) off the walking platform. Be careful to keep the		Rear Roller
walking belt centered. Then, plug in the power cord,
insert the key, and run the treadmill for a few min-		Bolts
utes. Repeat until the walking belt is properly tight-
ened.
c. If the walking belt still slows when walked on, please see the front cover of this manual.
The walking belt is off-center or slips when walked on
a. If the walking belt has shifted to the left, first re-	a
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn the left rear roller bolt clock-
wise 1/2 of a turn. Be careful not to overtighten the
walking belt. If the walking belt has shifted to the
right, turn the left rear roller bolt counterclockwise 1/2
of a turn. Then, plug in the power cord, insert the key,
and run the treadmill for a few minutes. Repeat until
the walking belt is centered.
b. If the walking belt slips when walked on, first re-	b
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both rear roller bolts clock-
wise, 1/4 of a turn. When the walking belt is correctly
tightened, you should be able to lift each edge of the
walking belt 2 to 3 in. (5 to 8 cm) off the walking plat-
form. Be careful to keep the walking belt centered.
Then, plug in the power cord, insert the key, and
carefully walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.

19