PART | R0905A | ||||
Key No. | Qty. | Description | Key No. | Qty. | Description |
1 | 1 | Motor Hood | 51 | 1 | Key/Clip |
2 | 13 | 3/4” Screw | 52 | 1 | Console Base |
3 | 16 | 3/4” Tek Screw | 53 | 1 | Left Handrail |
4 | 5 | 8” Cable Tie | 54 | 1 | Console Cover |
5 | 4 | 1” Tek Screw | 55 | 1 | Console |
6 | 1 | Warning Decal, Console | 56 | 2 | 3/8” Nut |
7 | 3 | Cable Tie Clamp | 57 | 2 | Handrail Foam |
8 | 2 | Foot Rail | 58 | 1 | Belly Pan Grommet |
9 | 4 | Isolator | 59 | 1 | Right Handrail |
10 | 4 | Front Platform Screw | 60 | 1 | Wire Harness |
11 | 3 | Rear Roller Star Washer | 61 | 4 | 5/16” Nut |
12 | 2 | Incline Leg Washer | 62 | 4 | 2” Bolt |
13 | 3 | Wheel Nut | 63 | 4 | Base Pad |
14 | 2 | Belt Guide | 64 | 1 | Hex Key |
15 | 4 | Belt Guide Screw | 65 | 4 | 2 1/2” Bolt |
16 | 1 | Reed Switch Clip | 66 | 8 | 3/8” Washer |
17 | 1 | Reed Switch Screw | 67 | 1 | Flywheel |
18 | 2 | Hood Anchor | 68 | 2 | Wheel |
19 | 1 | Drive Motor | 69 | 1 | Silver Ground Screw |
20 | 2 | Wire Tie | 70 | 2 | 4” Bolt |
21 | 2 | Frame | 71 | 2 | Plastic Bushing |
22 | 2 | Motor Tension Bolt | 72 | 1 | Walking Belt |
23 | 1 | Motor Isolator Plate | 73 | 1 | Belly Pan |
24 | 1 | Motor Star Washer | 74 | 1 | Walking Board |
25 | 2 | Motor Tension Nut | 75 | 1 | Large Warning Decal |
26 | 1 | Motor Pivot Bolt | 76 | 1 | Reed Switch/Sensor Wire |
27 | 2 | Frame Spacer | 77 | 1 | Drive Roller/Pulley |
28 | 1 | Outlet Adapter | 78 | 2 | Drive Motor Bolt |
29 | 2 | 3/8” Star Washer | 79 | 1 | Frame |
30 | 1 | Power Cord | 80 | 2 | Incline Pin |
31 | 1 | Controller | 81 | 2 | Incline Leg |
32 | 11 | Electronic Screw | 82 | 2 | Incline Leg Cap |
33 | 1 | Filter | 83 | 1 | Right Endcap |
34 | 2 | Bracket Grommet | 84 | 1 | Console Insert |
35 | 1 | Electronics Bracket | 85 | 1 | Rear Roller |
36 | 1 | On/Off Switch | 86 | 1 | Transformer |
37 | 1 | Circuit Breaker | # | 1 | 4” Green/Yellow Wire |
38 | 9 | Roller Adjustment Washer | # | 1 | 8” Red Wire, M/F |
39 | 1 | Front Roller Adjustment Bolt | # | 1 | 6” Black Wire, M/F |
40 | 2 | Plastic Fastener | # | 1 | 12” Blue Wire, 2F |
41 | 1 | Motor Belt | # | 1 | 6” Blue Wire, M/F |
42 | 1 | Receptical | # | 1 | 8” Blue Wire, 2F |
43 | 2 | Rear Roller Adjustment Bolt | # | 1 | 4” Black Wire, 2F |
44 | 1 | Latch Pin Assembly | # | 1 | 8” White Wire, 2F |
45 | 2 | Rear Platform Screw | # | 1 | 8” Green/Yellow Wire, F/Ring |
46 | 1 | Base | # | 1 | 10” Green/Yellow Wire, F/Ring |
47 | 1 | Magnet | # | 1 | User’s Manual |
48 | 1 | Latch Housing |
|
|
|
49 | 1 | Left Endcap | Note: “#” indicates a | ||
50 | 1 | Motor Bracket |
|
|
|
Specifications are subject to change without notice. See the back cover of the user’s manual for information about ordering replacement parts.