Newcon Optik LAM 3 IR operation manual Ilp

Page 10

OFF LAM is off

RVisible aimer is on

PIR aimer is on

IL

Illuminator is on

ILP

Both IR aimer and Illuminator are

 

on

BT

Battery test

The LED (14, Fig. 2) in BT mode indicates battery level: solid red LED means the battery charge is normal, if it is blinking - the battery must be replaced.

IR channels of LAM can operate at high (H mode) and low (L mode) power levels of laser. Low mode or IR channels are used for training purposes. Appropriate level can be chosen with switch (15, Fig. 2). Red channel is switched into the training mode by means of removable filter.

To prevent unintentional switching to high power mode, switch (15, Fig. 2) is blocked with the ring (12, Fig. 2). To unblock the switch and allow high power mode (H) the ring must be pulled out and turned.

6

Page 9 Page 11
Image 10
Page 9 Page 11
Contents LAM 3 IR Laser Radiation -AVOID Exposure to the Beam Important Information Read prior to activationPage Contents Brief description LAM 3IR Appearance Front viewPage Page ILP Page Page Delivery SET Standard delivery setSpecifications Aimer IlluminatorOperation Instructions Hazardous for Your EyesAdjusting with help of laser boresight Adjusting LAM on a weaponMounting LAM on a weapon Adjusting with iron weapon sight Aiming Preparing LAM for transportation CARE, Storage and Transportation GeneralTo remove old layer of lubricant Long-term storageTo apply new layer of lubricant Page Transportation Troubleshooting LED indicator is off when switch is onWarranty What This Warranty Does Not CoverPage Customer Support Quality Certificate Page Page Page Newcon OPTIK
Top Page Image Contents