Newcon Optik LAM 3 IR operation manual Troubleshooting, LED indicator is off when switch is on

Page 24

6. TROUBLESHOOTING

The LED indicator is off when switch is ON.

Turn the switch on again. If LAM still does not go ON check that battery is installed properly and has sufficient charge. Replace battery if necessary.

Spot shape or size has changed

Emitter objective lens is dirty. Flush emitter lens with fresh water and wipe it with soft cloth. If this doesn’t help, send LAM for repair.

No radiation when activating LAM with remote switch

Turn the mode switch (13, Fig. 2) to OFF position and then turn LAM ON again. If this doesn’t help, replace the remote switch.

Radiation doesn’t stop when remote switch is released

Replace the remote switch.

Moisture in the battery compartment.

Check the O-ring on the battery compartment cover and replace it if necessary. If the battery compartment cover is damaged, send LAM for repair

Shift of zero line when firing

Send LAM for repair.

20

Page 23 Page 25
Image 24
Page 23 Page 25
Contents LAM 3 IR Laser Radiation -AVOID Exposure to the Beam Important Information Read prior to activationPage Contents Brief description LAM 3IR Appearance Front viewPage Page ILP Page Page Delivery SET Standard delivery setSpecifications Aimer IlluminatorOperation Instructions Hazardous for Your EyesAdjusting LAM on a weapon Adjusting with help of laser boresightMounting LAM on a weapon Adjusting with iron weapon sight Aiming Preparing LAM for transportation CARE, Storage and Transportation GeneralLong-term storage To remove old layer of lubricantTo apply new layer of lubricant Page Transportation Troubleshooting LED indicator is off when switch is onWarranty What This Warranty Does Not CoverPage Customer Support Quality Certificate Page Page Page Newcon OPTIK
Top Page Image Contents