Sears NTL61011.1 Measure your heart rate if desired, HOW to USE the Stereo Sound System

Page 18

6. Measure your heart rate if desired.

When you are finished using the treadmill, press the power switch into the off position and unplug

Before using the heart rate moni- tor, remove the sheets of plastic from the metal contacts, if nec- essary. In addi- tion, make sure that your hands are clean.

Contacts

the power cord. IMPORTANT: If you do not do this, the treadmill’s electrical components may wear prematurely.

HOW TO USE THE STEREO SOUND SYSTEM

To play music or audio books through the console’s stereo speakers, you must connect your MP3 player, CD player, or other personal audio player to the con- sole through the MP3 jack.

To measure your heart rate, stand on the foot rails and hold the metal contacts on the handrails for approximately ten seconds—avoid moving your hands. When your pulse is detected, a heart symbol in the calorie display will flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.

7.When you are finished exercising, remove the key from the console.

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest set- ting or you may damage the treadmill when you fold it to the storage position. Next, remove the key from the console and put it in a secure place.

To use the MP3 jack, locate the included audio wire and plug it into the MP3 jack. Then, plug the audio wire into a jack on your MP3 player, CD player, or other personal audio player. Make sure that the audio wire is fully inserted.

Next, press the Play button on your MP3 player, CD player, or other personal audio player. Adjust the vol- ume on your personal audio player or press the vol- ume increase and decrease buttons on the console.

If you are using a personal CD player and the CD skips, set the CD player on the floor or another flat sur- face instead of on the console.

18

Image 18
Contents QUESTIONS? Model No. NTL61011.1 Serial NoCall TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedAge the Upright Wire Wire Page Screws, but do not tighten them yet Start all four Screws, and then tighten Again. if YOU do not Connect the CONHandrails 71, 72. Make sure that no wires Start both Screws, and then tighten themRaise the Frame 49 to the position shown Operation AND ADJUSTMENT HOW to Plug in the Power CordConsole Diagram Features of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleChange the incline of the treadmill as desired Follow your progress with the displaysHOW to USE the Stereo Sound System Measure your heart rate if desiredHOW to USE AN Onboard Workout Select an onboard workoutStart the workout Select an iFit Live workout HOW to USE AN IFIT LIVE WorkoutInsert the iFit Live module into the console Start the workout. See onInformation Mode MetricHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingSymptom The power does not turn on Power CordSymptom The walking belt slows when walked on Page Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing Exploded Drawing B Exploded Drawing C Exploded Drawing D Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT