Sears NTL61011.1 user manual

Page 4

20.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and press the power switch into the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the power switch.)

21.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 22.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22.When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23.Never insert any object into any opening on the treadmill.

24.Inspect and properly tighten all parts of the treadmill regularly.

25.DANGER: Always unplug the power cord immediately after use, before clean- ing the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servic- ing other than the procedures in this manual should be performed by an authorized ser- vice representative only.

26.This treadmill is intended for home use only. Do not use this treadmill in a commercial, rental, or institutional setting.

27.Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents Model No. NTL61011.1 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAge the Upright Wire Wire Page Screws, but do not tighten them yet Start all four Screws, and then tighten Again. if YOU do not Connect the CONHandrails 71, 72. Make sure that no wires Start both Screws, and then tighten themRaise the Frame 49 to the position shown Operation AND ADJUSTMENT HOW to Plug in the Power CordConsole Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired Follow your progress with the displaysHOW to USE the Stereo Sound System Measure your heart rate if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE AN IFIT LIVE Workout Insert the iFit Live module into the consoleSelect an iFit Live workout Start the workout. See onInformation Mode MetricHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Symptom The power does not turn onSymptom The power turns off during use Power CordSymptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT