Sears NTL61011.1 user manual HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 22

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight.

1

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch knob is locked in the storage position. Moving the treadmill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame

Handrail

Frame

Wheel

2.Raise the frame until the latch knob locks in the storage position. CAUTION: Make sure that the latch knob locks.

2

Frame

Latch

Knob

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in tem- peratures above 85° F (30° C).

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the treadmill with your right hand. Then, pull the latch knob to the left and hold it. IMPORTANT: Do not turn the latch knob. If necessary, push the frame forward slightly. Pivot the frame downward a few inches, and release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

22

Image 22
Contents Model No. NTL61011.1 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAge the Upright Wire Wire Page Screws, but do not tighten them yet Start all four Screws, and then tighten Again. if YOU do not Connect the CONHandrails 71, 72. Make sure that no wires Start both Screws, and then tighten themRaise the Frame 49 to the position shown Operation AND ADJUSTMENT HOW to Plug in the Power CordConsole Diagram Features of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleChange the incline of the treadmill as desired Follow your progress with the displaysHOW to USE the Stereo Sound System Measure your heart rate if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout Select an iFit Live workout HOW to USE AN IFIT LIVE WorkoutInsert the iFit Live module into the console Start the workout. See onInformation Mode MetricHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingSymptom The power does not turn on Power CordSymptom The walking belt slows when walked on Page Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT