Stamina Products 1350 owner manual Head SCREWSM5x0.8x15mm54

Page 10

ASSEMBLY INSTRUCTIONS

STEP 8

NOTE: The RIGHT PEDAL(35) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(35) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(34) has L stamped on the end of the pedal shaft. The LEFT PEDAL(34) has left hand threads and is tightened by turning counter clockwise.

Thread the RIGHT PEDAL(35) to the right side of the CRANK(9) as shown. Tighten the pedal securely. Do the same to attach the LEFT PEDAL(34) to the left side of the CRANK(9).

STEP 9

Install two AA batteries into the METER(27), two batteries included. See page 13 for detailed battery installation instructions. Plug the SENSOR WIRE(28) into the METER(27), and push the excess wires back into the METER POST(26). Place the METER(27) onto the plate on the METER POST(26) and secure with ROUND

HEAD SCREWS(M5x0.8x15mm)(54).

NOTE: Be careful not to damage the wires when attaching the METER(27).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents This Product is Produced Exclusively by Stamina ProductsSafety Instructions Table of ContentsCall US First 800Before YOU Begin Magnetic Recumbent 1350 BikeEquipment Warning & Notice Labels Hardware Identification Chart Part No. and Description QtyAssembly Instructions StepAssembly Instructions ARC WASHERSM865 Head SCREWSM5x0.8x15mm54 SET UP Instructions Function InspectionOperational Instructions Seat Adjustment Load AdjustmentHOW to Install and Replace Batteries Operational Instructions Using the MeterMODE/RESET Button FunctionsMaintenance StorageConditioning Guidelines Target Heart Rate Zone Estimated by AgeWARM-UP and COOL-DOWN Do not BounceLimited Warranty WarrantyProduct Parts Drawing FrontParts List Part NameParts List Page FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO
Top Page Image Contents